User manual YAMAHA LP-7 ASSEMBLY INSTRUCTIONS

[. . . ] numbers in a separate place in case your machine is stolen. 790-062 AE00011 MACHINE IDENTIFICATION The machine serial number is stamped in the location as shown. NOTE: The first three digits of these numbers are for model identification; the remaining digits are the unit production number. Keep a record of these numbers for reference when ordering parts from a Yamaha dealer. 790-025a AE00022 EF1600/EF2600/YG2600 OWNER'S MANUAL © 2003 by Yamaha Motor Corporation, U. S. A. 1st Edition, August 2003 All rights reserved. [. . . ] 9 Take care not to spill any fuel on the engine or muffler when refuelling. 9 If you swallow any fuel, inhale fuel vapor, or allow any to get in your eye(s), see your doctor immediately. If any fuel spills on your skin or clothing, immediately wash with soap and water and change your clothes. 9 When operating or transporting the machine, be sure it is kept upright. If it tilts, fuel may leak from the carburetor or fuel tank. 741-004 AE00843 ENGINE AND MUFFLER MAY BE HOT 9 Place the machine in a place where pedestrians or children are not likely to touch the machine. 741- 006 9 Avoid placing any flammable materials near the exhaust outlet during operation. 741-007 ­5­ a 9 Keep the machine at least 1 m (3 ft) from buildings or other equipment, or the engine may overheat. a 1 m (3 ft) 741-008a 9 Avoid operating the engine with a dust cover. 741-009 q 9 Be sure to carry the generator only by its carrying handle(s). 1 Carrying handle(s) (shaded) 741-067 AE00083 ELECTRIC SHOCK PREVENTION 9 Never operate the engine in rain or snow. 741-010 9 Never touch the machine with wet hands or electrical shock will occur. 741-011 q 9 Be sure to ground (earth) the generator. NOTE: Use ground (earth) lead of sufficient current capacity. 1 Lead diameter 741-012b ­6­ Ground (earth) Lead Diameter: 0. 12 mm (0. 005 in)/ampere EX; 10 Ampere 1. 2mm (0. 05 in) AE00088 q CONNECTION NOTES 9 Avoid connecting the generator to commercial power outlet. 9 Avoid connecting the generator in parallel with any other generator. 1 Correct 2 Incorrect AE00091 w CONNECTION q w Before the generator can be connected to a building's electrical system, a licensed electrician must install an isolation (transfer) switch in the building's main fuse box. The switch is the connection point for generator power and allows selection of generator or main line power to the building. This will prevent the generator from charging the main power line (backfeeding) when the main power supply has failed or has been turned off for line repair. Backfeeding can electrocute or injure line maintenance personnel. Also, generator and building electrical system damage can occur when normal operating power returns if unit is used without an isolation switch. AE00086 w 741-040a EXTENSION CORD NOTES 9 When using an extension cord, its total length should not exceed 60 meters for cross section of 1. 5 mm square and 100 meters for cross section of 2. 5 mm square. Add oil as necessary. 1 Upper level 700-068 q 700-110 Recommended oil: å YAMALUBE 4 (10W-30) or SAE 10W-30 type SE motor oil SAE #30 ç SAE #20 SAE 10W Engine oil quantity: 0. 6 L (0. 53 lmp qt, 0. 63 US qt) NOTE: Recommended engine oil classification: API Service "SE" or "SF". 0°C 25°C A YAMALUBE 4(10W-30) D SAE 10W C SAE #20 B SAE #30 32°F 80°F 700-065 cC The generator has been shipped without engine oil. Fill with oil or it will not start. 700-006 AE00241 GROUND (Earth) Make sure to ground (earth) the generator. Check "SAFETY INFORMATION" on page 6. 741-029a ­ 13 ­ AE00955 OPERATION q 700-006a NOTE: The generator has been shipped without engine oil. Fill with oil or it will not start. 1 Upper level AE00854 STARTING THE ENGINE NOTE: 9 Before starting the engine, do not connect any electric devices. 9 Turn the AC switch (N. F. B. ) to the "OFF" position. 1 q 3 "OFF" 761-027 ON OFF 763-086e 1. Turn the fuel cock lever to the "ON" position. 1 "ON" q 705-037 2. Turn the engine switch to the "ON" position. q 1 7 "ON" 763-084h 3. Turn the choke lever to the "1" position. q 1 Choke lever 701-025a NOTE: The choke is not required to start a warm engine. Turn the choke lever to the operating position. ­ 14 ­ 4. Pull slowly on the recoil starter until it is engaged, then pull it briskly. After the engine starts, warm up the engine until the engine does not stop when the choke lever is returned to the operating position. 704-010 6. [. . . ] Poor spark 2 Spark plug dirty with carbon or wet . . . . Compression Insufficient 2 Worn out piston and cylinder . . . . Replace gasket. 760-009 ­ 26 ­ AE00515 A ENGINE DOES NOT START B Turn the engine switch to "ON", then pull the recoil starter and check if the oil warning light flickers. E Check engine oil level. 791-001c 791-001e C Does not flicker D Flickers F OK Consult a Yamaha dealer. G Level low Add engine oil. H Pull the recoil starter and check the spark plug for spark strength. (See "WARNING") K Check the spark plug. [. . . ]