User manual YAMAHA MOTIF-RACK ES

[. . . ] OWNER'S MANUAL TONE GENERATOR EN SPECIAL MESSAGE SECTION This product utilizes batteries or an external power supply (adapter). DO NOT connect this product to any power supply or adapter other than one described in the manual, on the name plate, or specifically recommended by Yamaha. Battery Notice: This product MAY contain a small non-rechargeable battery which (if applicable) is soldered in place. The average life span of this type of battery is approximately five years. When replacement becomes necessary, contact a qualified service representative to perform the replacement. [. . . ] This synthesizer features a wide selection of various Equalizer Types, which can be used not only to enhance the original sound, but even completely change the character of the sound. The particular parameters and settings available depend on the specific Equalizer Type that is selected. Settings: EQ L/H (L/H), P. EQ, Boost6 (B6), Boost12 (B12), Boost18 (B18), thru EQ L/H (Low/High) . . . . . . . . . . . . . . . . This is a "shelving" equalizer, which combines separate high and low frequency bands. The Parametric EQ is used to attenuate or boost signal levels (gain) around the Frequency. This type features 32 different "Q" settings, which determine the frequency band width of the equalizer. Boost6 (Boost 6dB)/Boost12 (Boost 12dB)/Boost18 (Boost 18dB) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . These can be used to boost the level of the entire signal by 6dB, 12dB and 18dB, respectively. thru . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . If you select this, the equalizers are bypassed and the entire signal is unaffected. n The available parameters differ depending on which Filter type is selected here. When set to EQ L/H Gain + Low Freq Settings: 20. 1Hz ­ 2. 00kHz High Freq Settings: 503. 8Hz ­ 10. 1kHz When set to P. EQ Q (Frequency characteristic) Settings: 0 ­ 31 + Gain 0 0 Frequency ­ ­ Low Gain Settings: -32 ­ 0 ­ +32 High Gain Settings: -32 ­ 0 ­ +32 Frequency Gain Settings: -32 ­ 0 ­ +32 Freq Settings: 139. 7Hz ­ 12. 9kHz 72 Owner's Manual Voice mode Voice Edit (for Drum Voice) Voice Edit (for Drum Voice) When a Drum Voice is selected, Voice Edit parameters are divided into Common Edit (parameters common to all keys, up to 73), and Key Edit (parameters of individual keys). Common Edit [SHIFT]+[DRUM] select Drum Voice [EDIT] [SHIFT]+[COMMON] select each display with PAGE [E][F] These parameters are for making global (or common) edits to all keys of the selected Drum Voice. General Same as the General display in Normal Voice Common Edit. The following parameters are not available for Drum Voice: Mono/Poly settings, Key Assign mode settings, Portamento settings, Micro tuning settings Output InsRevSend Insertion Reverb Send Same as the Output display in Normal Voice Common Edit. In addition, the following two parameters are also available. Determines the Send level for the entire Drum Voice (all keys), sent from Insertion Effect 1/2 to the Reverb Effect. Settings: 0 -127 InsChoSend Insertion Chorus Send Determines the Send level for the entire Drum Voice (all keys), sent from Insertion Effect 1/2 to the Chorus Effect. Settings: 0 -127 n Send level (to Reverb and Chorus) cannot be set independently for each Drum key. n The value for each Normal Voice is fixed at 127 (maximum). EG/FLT (Envelope Generator/Filter) Same as the EG/FLT display in Normal Voice Common Edit. The following parameters are only available for Drum Voice: AEG Attack, AEG Decay, Cutoff, Resonance AEG Attack, AEG Decay, Cutoff, Resonance Key Edit These parameters are for editing the individual keys that make up a Drum Voice. OSC (Oscillator) WaveType Wave Type Determines whether a Wave or a Normal Voice is to be used for the selected key. Also, use the Bank, Number and Category parameters below to specify the desired Wave or Normal Voice. Settings: PresetWave, Voice n Depending on the settings here, some of the parameters may not be available. Multi mode Performance mode [SHIFT]+[DRUM] select Drum Voice [EDIT] select Key with [SHIFT]+PART [E][F] select each display with PAGE [E][F] Voice mode CtrlSet (Controller Set) Same as the CtrlSet display in Normal Voice Common Edit. Please note that the Element Switch parameter is not available in Drum Voice Common edit. ElementSw Element Switch This parameter is available when "WaveType" is set to "PresetWave. " This determines whether the currently selected key is on or off, or in other words, whether the wave for the key is active or inactive. Settings: on, off Effect Bank Bank This parameter is available when "WaveType" is set to "Voice. " Any of the Normal Voice banks can be selected. n You cannot select Plug-in Voices. Number Number Selects a Wave/Normal Voice Number. The number differs depending on the selected Wave Type. Details about each Wave/Voice are given in the separate Data List. Arpeggio Settings: When "WaveType" is set to "PresetWave": off, 0001 ~ 1859 When "WaveType" is set to "Voice": 001 ~ 128 WaveCtgry Wave Category Determines the Category of the Wave/Voice. If you switch to another Category, the first Wave/Voice in that Category will be selected. Settings: For more information on the Categories, refer to the separate Data List. InsEFOut Insertion Effect Output Settings: thru, ins1 (Insertion Effect 1), ins2 (Insertion Effect 2) RevSend/ChoSend Reverb Send/Chorus Send Determines the level of the Drum key sound (the bypassed signal) that is sent to Reverb/Chorus Effect. [. . . ] 09300, México, D. F. , México Tel: 55-5804-0600 SPAIN/PORTUGAL Yamaha-Hazen Música, S. A. 17, 200, 28230 Las Rozas (Madrid), Spain Tel: 91-639-8888 KOREA Yamaha Music Korea Ltd. 16F 23-8 Yoido-dong, Youngdungpo-ku, Seoul, Korea Tel: 02-3770-0660 BRAZIL Yamaha Musical do Brasil Ltda. Rua Joaquim Floriano, 913 - 4' andar, Itaim Bibi, CEP 04534-013 Sao Paulo, SP. [. . . ]