User manual YAMAHA MY8-SDI-D

[. . . ] HD-SDI DEMULTIPLEXER CARD EN DE FR ES IT RU ZH JA ITALIANO ESPAÑOL FRANÇAIS MY8-SDI-D DEUTSCH ENGLISH FCC INFORMATION (U. S. A. ) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. [. . . ] To take full advantage of the superior functionality of the MY8-SDI-D and enjoy years of trouble-free use, please read this manual before you begin using the product. * This card does not support SD-SDI. About the host devices in which the MY8-SDI-D can be installed Before installing the card in a host device, please refer to the Yamaha Pro Audio web site for the latest information on the compatible host devices in which the card can be installed. Yamaha Pro Audio website: http://www. yamahaproaudio. com/ Installation information Please refer to the owner's manual supplied with the host device for installation information. In addition to securing the card in place, the fixing screws at the left and right of the card function as electrical grounds. Be sure to screw them in tightly. Accessories Owner's Manual MY8-SDI-D Owner's Manual 5 ENGLISH Introduction Part Names and Functions Panel MODE Switches Move the switches down to set to ON. Raise the switches to set to OFF. Do not change the switch settings if the host device is powered on. ON ON ENGLISH OFF 1 2345 12345678 12345678 67 A GROUP SELECT Switches (SW1­4) 8 Set these switches to ON to select the following embedded audio groups. Up to two groups of audio can be input to slot channels 1-4 and 5-8. SW1 Group1 (ch1­4) SW2 Group2 (ch5­8) SW3 Group3 (ch9­12) SW4 Group4 (ch13­16) Note: · If only one switch is set to ON, audio will be input to channels 1-4, but not to channels 5-8. · If all four switches are set to OFF, no audio will be input to any channels. 6 MY8-SDI-D Owner's Manual SDI signal Group1: ch1-4 Group2: ch5-8 ON Slot (host device) input channels ch1-4 ch5-8 12345678 Group3: ch9-12 Group4: ch13-16 B SYNC Switch (SW5) Typically set this switch to OFF. OFF: An audio clock will be generated based on the phase data of the embedded audio. ON: An audio clock will be generated from video signals. If the SYNC switch is set to ON, the phase between audio groups may not be identical. Set this switch to ON only if you cannot input audio with the switch set to OFF. C MUTE Switch (SW6) Typically set this switch to OFF. OFF: Audio will not be muted regardless of whether or not an HD-SDI input error is detected. ON: Audio will be muted if an HD-SDI input error is detected (the STATUS LED lights up in a color other than green). Use this setting if you want to use muted audio to indicate an error. Note: Keep in mind that connecting or disconnecting a cable may cause noise even if this switch is set to ON. D ERROR FILTER Switch (SW7) Typically set this switch to OFF. This switch is used to analyze the causes of errors. MY8-SDI-D Owner's Manual 7 ENGLISH · If more than two GROUP SELECT switches are set to ON, only the first two switches (in ascending order) will actually be on. For example, if SW2, SW3, and SW4 are set to ON, Group 2 and Group 3 audio will be input to slot channels 1-4 and 5-8 respectively, and Group 4 audio will not be input. OFF: A filter is not applied to a detected HD-SDI input error. Each STATUS LED indicates the type of all HD-SDI input errors as shown in the list below. Audio will be muted if SW6 is set to ON. HD-SDI Input Errors Details Video standard error Chromaticity checksum error Brightness checksum error Chromaticity CRC error Brightness CRC error Line number error Start of active line (SAV) code word error End of active line (EAV) code word error ON error -- -- -- -- -- -- -- OFF error error error error error error error error ENGLISH ON: A filter is applied to a detected HD-SDI input error (excluding the video standard error). The STATUS LEDs will not indicate an error status. Audio will be input to the slot channels, and will not be muted regardless of the SW6 setting. E ERROR FILTER Switch (SW8) Typically set this switch to OFF. [. . . ] 135 Milner Avenue, Scarborough, Ontario, M1S 3R1, Canada Tel: 416-298-1311 U. S. A. Yamaha Corporation of America 6600 Orangethorpe Ave. , Buena Park, Calif. Tel: 714-522-9011 SWITZERLAND/LIECHTENSTEIN Yamaha Music Central Europe GmbH, Branch Switzerland Seefeldstrasse 94, 8008 Zürich, Switzerland Tel: 01-383 3990 AUSTRIA Yamaha Music Central Europe GmbH, Branch Austria Schleiergasse 20, A-1100 Wien, Austria Tel: 01-60203900 CZECH REPUBLIC/SLOVAKIA/ HUNGARY/SLOVENIA Yamaha Music Central Europe GmbH, Branch Austria, CEE Department Schleiergasse 20, A-1100 Wien, Austria Tel: 01-602039025 POLAND Yamaha Music Central Europe GmbH Sp. z. 17 Stycznia 56, PL-02-146 Warszawa, Poland Tel: 022-868-07-57 THE NETHERLANDS/ BELGIUM/LUXEMBOURG Yamaha Music Central Europe GmbH, Branch Benelux Clarissenhof 5-b, 4133 AB Vianen, The Netherlands Tel: 0347-358 040 FRANCE Yamaha Musique France BP 70-77312 Marne-la-Vallée Cedex 2, France Tel: 01-64-61-4000 ITALY Yamaha Musica Italia S. P. A. [. . . ]