User manual YAMAHA NS-10MT

[. . . ] NS-10MT Thank you for selecting the Yamaha NS-10MT speaker system. Natural Sound Bass-Reflex Type 2-Way Speaker System PRECAUTIONS Read these precautions carefully before operating your speaker. When using an amplifier with a rated output power higher than the nominal input power of the speaker, care should be taken never to exceed the speaker's maximum input. [. . . ] YAMAHA shall not be liable to any accident caused by an improper placing of the speaker. CONNECTION TO YOUR AMPLIFIER BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE AMPLIFIER IS SWITCHED OFF. s CONNECTIONS Connect the screw-type input terminals at the rear of the speaker to the speaker output terminals of your amplifier with the provided speaker cables. One side of the speaker cable is marked by a white line. Connect the (+) terminals on both the amplifier and the speakers using this white-marked side. Connect the (­) terminals on both components using the unmarked side of the cable. If connected with reversed polarity, the sound will be unnatural and lack bass. Insert the bare wire end properly into the terminal hole. 10 mm (3/8") insulation from the speaker cable. ] Tighten the knob. Test the security of the connection by tugging lightly on the cable at the terminal. Left Right R L Amplifier Note Do not let the bare speaker wires touch each other as this could damage the speaker and/or the amplifier. * Banana Plug connections are also possible. First tighten the terminal knobs, and then insert the Banana Plug connector into the corresponding terminal hole. Loosen Tighten Black(­) Red (+) White line PLACING THE SPEAKER Place the speaker on a sturdy, vibration-free surface. If you cannot obtain good bass quality when the speaker is placed directly on the floor, insert a block etc. Better stereo images will be obtained when the speakers are slightly angled in towards the listener. REMOVING THE FRONT COVER The front cover is fastened to the enclosure at four points, and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. [. . . ] Be careful not to obstruct the opening or put some objects into it. If doing so, the sound will be unnatural or it may cause damage to the speaker and/or amplifier. Opening VU58660 [. . . ]