User manual YAMAHA NS-2HX

[. . . ] A vessel with water in it If the vessel falls by vibrations and water spills, it may cause damage to the speakers, and/or you may get an electric shock. Do not place the speakers where foreign objects such as water drips might fall. It might cause a fire, damage to the speakers, and/or personal injury. [. . . ] Determine the best position by following the owner's manual supplied with your amplifier. The screw holes on the rear of the speakers can be used when mounting the speakers using a commercially available speaker bracket. Screw holes (diameter: 6 mm) 60 mm NS-2HX (Front effect R) NS-2HX (Front effect L) NS-2HX (Main R) Subwoofer NS-2HX (Main L) Center NS-2HX (Effect R) NS-2HX (Effect L) Note These speakers feature a magnetically shielded design, but there is still a chance that placing them too close to a TV set might impair picture color. Should this happen, move the speakers away from the TV set. E-1 CONNECTIONS TO YOUR AMPLIFIER This speaker system is capable of standard connections and bi-wired connections. Before making connections, make sure that the amplifier is switched off. <Standard connections> Leave the short bars in place when connecting. Short bar Loosen Tighten ICONNECTIONS · Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of the amplifier (or receiver) with the speaker cable. · Connect the (+) terminals on the amplifier (or receiver) and the speakers using one side of the cable. Connect the (­) terminals on both components using the other side of the cable. · Connect one speaker to the left (marked L) terminals of your amplifier, and another speaker to the right (marked R) terminals, making sure not to reverse the polarity (+, ­). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass. [Remove the insulation coating at the extremity of each speaker cable by twisting the coating off. ] 3 Tighten the knob and secure the cable. Test the firmness of the connection by pulling lightly on the cable at the terminal. A + ­ NS-2HX (R) NS-2HX (L) SPEAKERS R L Speakers output terminals of the amplifier (or receiver) + ­ ­ + B Note Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both of them. Amplifier or Receiver E-2 English <Bi-wired connections> Remove the short bars before connecting. Tweeter terminals Bi-Wired Connections This speaker system is capable of bi-wired connections. To connect the speaker to the output terminals of the amplifier (or receiver), two pairs of cables for each of woofer and tweeter are used instead of standard connections. [. . . ] 8 oz. ) G Specifications subject to change without notice due to product improvements. G Care should be taken not to exceed the input power values noted above. Note When the cover is removed, take care not to touch the speaker units with your hands or to exert excessive force with tools. E-4 YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE. , BUENA PARK, CALIF. 135 MILNER AVE. , SCARBOROUGH, ONTARIO M1S 3R1, CANADA ELECTRONIK EUROPA G. m. b. H. [. . . ]