User manual YAMAHA NS-C200

[. . . ] English NS-C200 OWNER'S MANUAL Speaker System Thank you for selecting this YAMAHA NS-C200 speaker system. GTR PRECAUTIONS Read these precautions carefully before using your speaker. q Any time you note distortion, reduce the volume control on your amplifier to a lower setting. Never allow your amplifier to be driven into "clipping". [. . . ] The center speaker should be set in alignment with the center of the TV screen. The positioning of the center speaker is important, because it controls the whole sound quality of a multi channel system. Set up the center speaker on the basis of your listening position by following the owner's manual supplied with your amplifier. 1 Velcro strip Notes q Do not place the center speaker on top of the TV whose area is smaller than the bottom area of the speaker. If placed, the speaker may fall and possibly cause damage or personal injury. q Though this speaker is magnetically shielded, there may be some influence on the TV picture depending on the type of TV or the placement of the speaker. In such a case, place the speaker away from the TV so that there is no influence on the TV picture. 2 Front Effect Speakers NS-C200 Main R Subwoofer Main L Rear Speakers CONNECTIONS TO YOUR AMPLIFIER Before making connections, make sure that the amplifier is switched off. REMOVING THE FRONT COVER The front cover is fastened to the enclosure at four points, and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four pegs on the inside surface of the cover with the four corresponding holes on the speaker and push gently. Loosen Tighten Black (­) Red (+) ­ + Center speaker Note When the cover is removed, take care not to touch the speaker units with your hands or to exert excessive force with tools. SPECIFICATIONS CENTER + ­ Amplifier or Receiver s Connections q q q Connect the screw-type input terminals at the rear of the speaker to the speaker output terminals of your amplifier with the speaker cables. Connect the (+) terminals on both the amplifier and the speaker using one side of the cable. Connect the (­) terminals on both components using the other side of the cable. Connect the speaker to the center terminals of your amplifier, making sure not to reverse the polarity (+, ­). If this speaker is connected with reversed polarity, the sound will be unnatural and lack bass. Type . . . . . . . . . . . . . . . . . . . . . . . . . . 2-way 3-speaker bass reflex speaker system (Magnetically-shielded type) Driver . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 cm cone woofer x 2 3 cm dome tweeter Nominal Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 ohms Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 57 Hz ­ 35 kHz Nominal Input Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 10 mm insulation from the speaker cable and insert the bare wire end properly into the terminal hole. Test the security of the connections by tugging lightly on the cable at the terminal. Note Do not let the bare speaker wires touch each other as this could damage the speaker and/or the amplifier. V556620 [. . . ]