User manual YAMAHA NS-C325

[. . . ] Install the speaker in a cool, dry, clean place ­ away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, do not expose the speaker to rain or water. To prevent the enclosure from warping or discoloring, do not place the speaker where it will be exposed to direct sunlight or excessive humidity. [. . . ] Do not attempt to modify or fix the speaker. Contact qualified YAMAHA service personnel when any service is needed. The cabinet should never be opened for any reasons. Secure placement or installation is the owner's responsibility. YAMAHA shall not be liable for any accident caused by improper placement or installation of the speaker. Deutsch · · · Español · · · · · Supplied Accessories Fastener x 4 E-1 PLACING THE SPEAKER Place the speaker on TV whose top is flat or on the floor under the TV or inside the TV rack so that it is stabilized. When placing the speaker on top of the TV, to prevent the speaker from falling down, put the provided fasteners at four points on the bottom of the speaker and the top of the TV. Front R Subwoofer Front L 1 2 NS-C325 Center surround back Fastener surround Notes · Do not place the speaker on top of the TV whose area is smaller than the bottom area of the speaker. If placed, the speaker may drop out causing an injury to you. · Do not place the speaker on top of the TV with an inclination. · Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength. · · Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop. This speaker features a magnetically shielded design, but there is still a chance that placing it too close to a TV set might impair picture color or create a buzzing noise. Should this happen, move the speaker away from the TV set. CONNECTIONS TO YOUR AMPLIFIER Before making connections, make sure that the amplifier is switched off. CONNECTIONS · Connect the screw-type input terminals at the rear of the speaker to the speaker output terminals of the amplifier (or receiver) with the speaker cable. · Connect the (+) terminals on the amplifier (or receiver) and the speaker using one side of the cable. Connect the (­) terminals on both components using the other side of the cable. · Connect the speaker to the center terminals of your amplifier, making sure not to reverse the polarity (+, ­). If the speaker is connected with reversed polarity, the sound will be unnatural and lack bass. How to connect: NS-C325 1 Loosen the knob. 2 Remove the insulation coating at the extremity of each speaker cable by twisting the coating off. Loosen Black (­) Tighten Red (+) + ­ CENTER + ­ 3 Insert the bare wire. [. . . ] 200 W Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 88 dB/2. 83 V/m Crossover Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2. 5 kHz Dimensions (WxHxD) . . . . . . . . . . . . . . . . . . . . . . . . . 430 x 140 x 200 mm (16-15/16" x 5-1/2" x 7-7/8") Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]