User manual YAMAHA NS-P60

[. . . ] Secure placement or installation is the owner's responsibility. YAMAHA shall not be liable for any accident caused by improper placement or installation of the speaker. Place the speaker on top of the TV or on the floor under the TV or inside the TV rack so that it is stabilized. [. . . ] 10 mm (3/8") insulation from the speaker cord. ] Tighten the knob. Test the security of the connection by pulling lightly the cord at the terminal. NS-C55 SPECIFICATIONS Type. . . . . . . . . . . . . . . . . . . . . . . . . . 2-way 3-speaker acoustic-suspension speaker system Magnetic-shielding type Speaker Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 cm cone woofer x 2 2. 2 cm dome tweeter Input Terminal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Screw-type Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 ohm Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70 Hz ­ 30 kHz Nominal Input Power. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60W Maximum Input Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 180W Sensitivity (2. 83V, 1m) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 91 dB Crossover Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 kHz Dimensions (WxHxD). . . . . . . . . . . . . . . . . . . . . . . 465 x 135 x 173. 5 mm (18-5/16" x 5-5/16" x 6-7/8") Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3. 5 kg (7 lbs. 12 oz. ) Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Speaker cord (4m) x 1 Velcro strip x 2 * Specifications subject to change without notice due to product improvements. * Care should be taken not to exceed the input power values noted above. Loosen Tighten Black (­) Red (+) Center speaker output terminals of the amplifier Red Amplifier Note Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both of them. V415010 NS-E55 Natural Sound Effect Speaker System SETTING UP THE SPEAKERS s Mounting the speakers on a wall The speakers can be mounted on a wall by using the holes provided on the speakers' back panels. Fasten screws into a firm wall or wall support as shown in the figure below, and hang the holes on the protruding screws. PRECAUTIONS This model is designed to be used as an effect speaker system. Read these precautions carefully before using your speakers. Any time you note distortion, reduce the volume control on your amplifier to a lower setting. Never allow your amplifier to be driven into "clipping". When using an amplifier with a rated output power higher than the nominal input power of the speakers, care should be taken never to exceed the speakers' maximum input. Do not attempt to clean the speakers with chemical solvents as this might damage the finish. To prevent the enclosure from warping or discoloring, do not place the speakers where they will be exposed to direct sunlight or excessive humidity. Do not place the speakers where they are liable to be knocked over or struck by falling objects. Stable placement will also ensure better sound performance. Placing the speakers on the same shelf or rack as the turntable can result in feedback. As these speakers contain strong magnets, avoid placing watches, magnetic tapes, etc. Also, placing the speakers near a TV set may impair picture color. If this happens, move the TV set away from the speakers. Secure placement or installation is the owner's responsibility. [. . . ] Connect the (­) terminals on both components using the side without a gray line. Connect one speaker to the left (marked L) terminals of your amplifier, and another speaker to the right (marked R) terminals, making sure not to reverse the polarity (+, ­). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass. [. . . ]