User manual YAMAHA PCS30E

[. . . ] MODEL: Serial No. : The serial number is located on the rear of the unit. Retain this Owner's Manual in a safe place for future reference. 13 14 Read these instructions. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] C PTY SEEK START Press this button to begin searching for a station after the desired program type has been selected in the PTY SEEK mode. D EON Press this button to select a radio program type (NEWS, INFO, AFFAIRS, SPORT) to tune in automatically. 3 CONTROLS AND FUNCTIONS Front panel display 1 2 3 4 56 AUTO ST kHz MHz MEMO PS PTY RT CT EON NEWS INFO AFFAIRS SPORT EDIT PTY HOLD 7 8 9 0 A 1 Preset station indicator Displays the group (A to E) and number (1 to 8) of the selected preset station. 2 Station frequency display Displays the band and frequency or information about the station being received. 3 AUTO indicator Lights up to indicate that automatic tuning is possible. 4 ST (stereo) indicator Lights up when this unit is receiving a strong signal for an FM stereo broadcast. 5 Signal-level meter Indicates the signal level of the station being received. If multi-path interference is detected, the indication decreases. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals. Indoor FM antenna (included) Outdoor FM antenna Outdoor AM antenna Use a 5 to 10 m (16. 4 to 32. 8 ft) of vinyl-covered wire extended outdoors from a window. AM loop antenna (included) Antenna adapter (included for U. S. A. and Canada models only) FM ANT GND AM ANT 75 UNBAL 75-ohm coaxial cable 300-ohm feeder cable 75-ohm/300-ohm antenna adapter (included for U. K. model only) 75-ohm coaxial cable Ground (GND terminal) For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. · Keep the feeder cable or coaxial cable as short as possible. · The antenna should be placed at least 2 meters (6. 6 ft) from reinforced concrete walls or metal structures. FREQUENCY STEP switch (Asia and General models only) Because the interstation frequency spacing differs in different areas, set the FREQUENCY STEP switch on the rear panel of this unit according to the frequency spacing in your area. · North, Central and South America: 100 kHz/10 kHz · Other areas: 50 kHz/9 kHz Before setting this switch, disconnect this unit's AC power plug from the AC wall outlet. FREQUENCY STEP FM AM 100kHz 10kHz 50kHz 9kHz 8 CONNECTIONS Connecting an amplifier CAUTION Do not connect this unit or other components to the main power until all connections between components are complete. This unit (U. S. A. model) FM ANT GND AM ANT FREQUENCY STEP LINE OUT VOLTAGE SELECTER Note Be sure to connect the left ("L") and right ("R") LINE OUT jacks to the corresponding (left and right) input jacks of the amplifier. 220V-240V 75 UNBAL R FM AM 100kHz 10kHz 50kHz 9kHz L 110V-120V 2 SETUP To an AC wall outlet R L Audio pin cable (included) R L Amplifier POWER CD/DVD STANDBY PHONO TUNER STANDBY POWER ON OFF AUX MD TAPE CD/DVD TUNER PHONO PURE DIRECT CD/DVD DIRECT AMP MD TAPE AUX u + VOLUME TUNER STANDBY /ON VOLUME PRESET INPUT PHONES SPEAKERS A B 3 ON OFF 4 4 5 d BASS 1 2 1 2 3 3 4 4 5 2 ­ TREBLE 1 1 2 3 3 BALANCE 1 2 1 2 3 4 L5 4 5R LOUDNESS 1 2 3 4 5 6 7 FLAT ­30dB 10 9 REC OUT TAPE MD AUX CD/DVD TUNER PHONO A/B/C/D/E A/B DISPLAY w DIR A e f DIR B REC DISC ­5 + ­5 + b s a CD TAPE p Controlling this unit with a remote control This unit has a remote control sensor. It receives signals from a remote control provided with a YAMAHA amplifier or AV receiver. Notes · Do not place any large obstacles between the remote control and this unit. · If the remote control sensor is directly illuminated by strong lighting (especially an inverter type fluorescent lamp), you may not be able to control this unit using the remote control. In this case, reposition this unit to avoid direct lighting. FREQ/TEXT EON FM/AM EDIT PTY SEEK MEMORY TUNING MODE MODE START MAN'L/AUTO FM AUTO/MAN'L A/B/C/D/E TUNING POWER 1 2 3 4 5 6 7 8 l h Approximately 6 m (19. 7 ft) 30 30 9 CONNECTIONS Connecting the power supply cord Connecting the AC power cord Plug the power cord into an AC wall outlet. Turning on the power When all connections are complete, turn on the power of this unit. POWER Memory back-up The memory back-up circuit prevents the stored data from being lost. However, the stored data will be lost if this unit is turned off for more than one week even when the power cord is connected. FREQ/TEXT EON FM/AM EDIT PTY SEEK MEMORY TUNING MODE MODE START MAN'L/AUTO FM AUTO/MAN'L A/B/C/D/E TUNING POWER 1 2 3 4 5 6 7 8 l h VOLTAGE SELECTOR (Asia and General models only) The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local main voltage BEFORE plugging into the AC main supply. Voltages are 110-120/220-240 V AC, 50/60 Hz. VOLTAGE SELECTOR Press POWER to turn on the power of this unit. POWER 220V-240V 110V-120V (Asia and General models) 10 TUNING TUNING Automatic and manual tuning There are 2 tuning methods; automatic and manual. Automatic tuning is effective when station signals are strong and there is no interference. Manual tuning If the signal from the station you want to select is weak, tune into it manually. [. . . ] 0. 1%/0. 2% · Stereo Separation (1 kHz) [U. K. and Europe models] (40 kHz dev. ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 dB [Other models] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 dB · Frequency Response (30 Hz to 13 kHz) . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]