User manual YAMAHA PCY65-65S-135-155

[. . . ] Please be careful when children are close to or touching the product. Careless movement around the product may result in injury. When setting the pads, please pay close attention to the handling and setting of cables. [. . . ] NOTE: The PCY series pads are supplied with a stopper that allows positioning of the pad at any angle when used. First, insert the stopper q underneath the cymbal support w, and then use a drum key (optional: YAMAHA DK20) to secure. Make sure that the rod on the stopper is inserted into the hole on the upper portion of the PCY65/65S. First, insert the stopper q underneath the cymbal support w, and then use a drum key (optional: YAMAHA DK20) to secure. Insert the stopper into the hole on the back side of the PCY135/155 so that YAMAHA logo mark appears in front. Using these felt washers instead of those that come with the rack system or cymbal stand offers optimum stability. The function of the PCY series pads varies according to which INPUT number on the DTX Series Drum Trigger Module the pad is connected. The chart below describes its function in relation to input numbers. * Make sure you set the module's pad type setting to cymbal. (Refer to the Owner's Manual that came with your module. ) A single voice can be assigned to and produced by the pad. Independent voices can be assigned to and produced by the pad and edge section (Dual Zone; the cup and pad sections share the same voice). A cymbal choke function (grabbing the edge section stops the voice being produced by the pad) is also available. Independent voices can be assigned to and produced by the pad and cup section (Dual Zone; the edge switch is inactive). Independent voices can be assigned to and produced by the pad section, and the edge/cup sections (Dual Zone; the edge and cup sections share the same voice). A cymbal choke function (grabbing the edge section stops the voice being produced by the pad) is also available. [. . . ] Controls the level of the trigger output from the PCY series pad. Rotate the knob to the right (+) to increase the output level, or to the left (­) to decrease it. The pad's output level should be adjusted depending on how hard you hit the pad, or to adjust the pad's dynamic range, or to better match the pad to the type of DTX Series Drum Trigger Module you are using. [. . . ]