User manual YAMAHA PDS-150

[. . . ] ­ PEDESTAL Installation Instructions Before attempting to assemble these accessories, please read these instructions completely. Please retain this book for future reference. Manuel d'installation Avant d'essayer d'essembler ces accessoires, veuillez lire ces instructions complètement. Veuillez garder ce manuel pour une rèfèrence future. Instrucciones de instalación Antes de instalar estos accesorios, lea cuidadosamente estas instrucciones. [. . . ] · Long-term usage in such conditions can cause warping or deformation. This can lead to loss of strength, and the unit may fall over and become damaged, and personal injury may result. During setting-up, make sure that all screws are securely tightened. · If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong enough to support the wide plasma display, and it might fall over and become damaged, and personal injury may result. Use the accessory fall-prevention brackets to secure the wide plasma display. · If the unit is knocked or children climb onto the pedestal with the wide plasma display installed, the wide plasma display may fall over and personal injury may result. Two people are required to install and remove the display. · If two people are not present, the display may be dropped, and personal injury may result. Notes on handling 1) If the unit is placed in direct sunlight or next to a stove, the light and heat may cause discoloration or deformation. 2) Cleaning Wipe the unit with a dry cloth. If the unit is particularly dirty, clean it using a cloth soaked with water to which a small amount of neutral detergent has been added, and then wipe with a dry cloth. Do not use products such as solvents, thinner or household wax for cleaning, as they can damage the surface coating. (If using a chemically-treated cloth, follow the instructions supplied with the cloth. ) 3) Do not attach sticky tape or labels, as they can make the surface of the pedestal dirty. 2 Assembling the pedestal / Setting-up Accessories for pedestal assembly Assembly screw . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Assembly screw (Black screw) . . . . 4 Pole . . . . . . . . . . . . . . . . . . . 2 Base . . . . . . . . . . . . . . . . . . 1 Assembling the pedestal The numbers (such as ) in the explanatory text indicate part numbers in the table of accessories. Assemble the poles correctly by referring to the illustrations below. 1. Securing the poles Pole Front Base Pole Pole For 50 display(Outside) Pole Insert the poles into the left and right holes in the underside of the base so that they fit securely as shown in the illustration above. Use the assembly screws to secure the poles firmly to the bottom of the base. Setting-up 1. Setting up the display unit Display unit Front Cloth or similar 2. Securing the display unit Display unit * Carry out work on a horizontal and level surface. [. . . ] YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD1 7JS, ENGLAND SCANDINAVIA A. B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST. , SOUTH MELBOURNE, 3205 VIC. , AUSTRALIA Printed in Japan M0602-0 [. . . ]