User manual YAMAHA PLG150DREDITOR

[. . . ] Plug-in Board Editor for PLG150-DR/PLG150-PC Owner's Manual Contents Introduction. . 3 Assigning the PLG150-DR/PLG150-PC to a Part . 4 Using the Plug-in Board Editor -- Example Operation . . 20 · Click on the red-colored text to jump to the related item in this manual. [. . . ] Each tab lists all the names and numbers of voices in the selected voice type group. Double-clicking a file (Voice Name) from the Library window automatically opens the Edit window for the selected voice. NOTE You can save your settings as a Library file (*. DRK/*. PCK). q w e q Toolbar This area holds the buttons controlling Plug-in Board Editor (Page 10). w Tabs Click one of these to view the voice list for that group. e Voice list This area shows all the voices in the selected group as a scrollable list. The name and number of each voice are shown. You can rearrange the voices by dragging-and-dropping their voice numbers to a new location. You can rename a voice in Windows by selecting the voice name, then clicking on it again to enter a new name. NOTE · To select a continuous block of voices, click the number of the first voice, hold down the [Shift] key, then click the last number. · Voice names can consist of up to 8 characters. 8 Viewing Just the Voice Names You can view just the names of all voices in the group without their "Number" information. Click this and choose the folder in which to save the file. Shows the contents of the folder you wish to save to. Specify the name of the file to be saved here. Click this to save the file as SMF with the name specified in the "File name:". Click this to close this dialog without saving. 12 r "Editor Setup" button Click this to open the "Setup" dialog. "Setup" Dialog This is where you set up the Plug-in Board Editor to allow the transmission of voice data to your plug-in board. Click the [OK] button to apply the settings and quit the dialog. Click the [Cancel] button to quit without applying the settings. NOTE For more information on the settings in this dialog, refer to the owner's manual or documentation for the particular "mother" device or client application. If you are using a Modular Synthesis Plug-in System compatible synthesizer, make sure the settings match the ones fixed on the instrument itself. (See chart on page 4. ) q w e r t y u i q "MIDI In Port:". . . . . . . . . . . This is unavailable for the Plug-in Board Editor. Click this and choose the MIDI Out port. You can use the Plug-in Board Editor to control and edit the device connected to this port. Select the port which has been assigned to your plug-in board within the client application. e "MIDI Ch:" . . . . . . . . . . . . . . . . . Click this and choose the MIDI Out channel. [. . . ] You can also change the settings by dragging the square in the graph. This graph shows the !0, !1 and !2 settings visually. You can also change the settings by dragging the squares in the graph. @2 FILTER !4 PAN Sets the Pan position of the wave. !5 INSERTION ON/OFF Selects whether or not to send the signal to the Insertion Effect Unit. @3 AMPLITUDE EG Parameter Knob Operation You can change the operation of the parameter knobs. Right click on any knob, and select "Rotate" or "Up/down or left/ right. " When "Rotate" is selected, the parameter values (of the panel "knobs") are changed by clicking and dragging the mouse in a circular direction. [. . . ]