User manual YAMAHA PORTASOUND PSS 31

[. . . ] A moment of inattention while operating power tools may result in serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. [. . . ] Wear a dust mask specifically designed for protection against dust and fumes and ensure that persons within or entering the work area are also protected. thoroughly remove all dust after routing. Only use router bits with a shank diameter equal to the size of the collet installed in the tool. Only use router bits suitable for the no-load speed of the tool. Never use router bits with a diameter exceeding the maximum diameter specified in the technical data section. do not use the tool in an inverted position. Do not attempt to use the tool in a stationary mode. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid hazard. Take special care when routing where the paint is possibly lead based or when routing some woods which may produce toxic dust: - Do not let children or pregnant women enter the work area. - Do not eat, drink or smoke in the work area. The declared vibration emission values stated in the technical data and the declaration of conformity have been measured in accordance with a standard test method provided by EN 60745 and may be used for comparing one tool with another. The depth of cut can be set in two different ways as described below. plunge the router down until the router bit touches the workpiece. Move the depth stop bar (9) down against the depth stop using the depth stop adjuster (31). reset the scale by aligning the zero marking (32) with the arrow (33). Move the depth stop bar (9) to the calculated position using the depth stop adjuster (31). Fit the template guide (13) to the base of the router, with the flange to the bottom (workpiece) side. Insert the two long screws (24) from the bottom side through the template guide and the holes in the base. Pull the plunge lock lever (5) up and return the router to its original position. After switching the router on, plunge it down and make the desired cut. Adjusting the depth of cut using a piece of wood (fig. Move the depth stop bar (9) up using the depth stop adjuster (31). [. . . ] Before performing any maintenance, switch off and unplug the tool. Regularly clean the ventilation slots in your tool using a soft brush or dry cloth. Regularly clean the motor housing using a damp cloth. Do not use any abrasive or solvent-based cleaner. [. . . ]