User manual YAMAHA PSS16

[. . . ] Doing so may result in injury or damage/deterioration to the product. If this symbol is ignored and the equipment is used improperly, there is a danger or injury to persons handling the equipment, and material damage could occur. Do not step on or place heavy objects on the product. Do not use or keep the product in places with extremely high temperature (places in direct sunlight, close to a heater, in a closed car, etc. [. . . ] Applying excessive force to the cable may result in damage to the cable, such as the wires being severed, etc. * To customers who purchased a Pads Set, please refer to the attached "Accessories List" sheet included with the Pads Set when confirming package contents. Q PCY65 main unit x 1, y stopper x 1, o stereo phone cable x 1, ! 0 Owner's Manual (this sheet) x 1 w PCY65S main unit* x 1 , y stopper x 1 , o stereo phone cable x 1 , !0 Owner's Manual (this sheet) x 1 e PCY130 main unit x 1, u stopper x 1, i felt washer (thin) x 1, o stereo phone cable x 1, !0 Owner's Manual (this sheet) x 1 r PCY130SC main unit* x 1, u stopper x 1, i felt washer (thin) x 1, o stereo phone cable x 1, !0 Owner's Manual (this sheet) x 1 t PCY150S main unit* x 1, u stopper x 1, i felt washer (thin) x 1, o stereo phone cable x 1, !* Switches are embedded in the edge section on the PCY65S and edge and cup sections on the PCY130SC and 150S. Si ce produit est utilisé avec le système de racks ou le support de cymbales, ne placez pas le rack ou le support sur une surface inclinée ou instable ou sur des marches. ) and then attach your cymbal pad as shown in the illustration. make sure that the pad is securely attached to the rack or stand. (Only the voice assigned to the pad can be produced. ) Since the PCY65/130 does not incorporate a switch, use of a mono phone cable is allowed. If the following trouble occurs when the PCY series pad is used, please check the following points before asking your dealer for assistance. Is the pad connected to the correct input number of the DTX Series Drum Trigger Module using the supplied stereo phone cable? (See "Pad-to-Input Matching Chart" above. ) When a pad with a switch(es) is connected with a mono phone cable, the voices assigned to the edge and cup sections are not produced. Increase the output level using the level adjustment knob on the pad. Hitting the pad once produces multiple sounds (double triggering) Decrease the output level using the level adjustment knob on the pad. Too high of a level adjustment setting causes the drum module to produce multiple sounds, because the large signal produced by the high settings sustains for too long of a time. (See "Output Level Adjustment" above. ) Also, please refer to the Owner's Manual that came with your DTX Series Drum Trigger Module for more information regarding the problems described above and any other problems that you may be experiencing. [. . . ] NOTE: When the PCY series pad is used with a DTX Series Drum Trigger Module, enter the module's Trigger Setup Edit display and set the Gain (pad input level) parameter so that the display reads 90-95% when the pad is struck strongly. Refer to the Owner's Manual that came with your module for more information. If the output level is too high, the pad's dynamic range (the difference between loud and soft sounds) will be reduced and problems such as double triggering (multiple triggers being produced by a single stroke) may occur. Do not put excessive pressure on the level adjustment knob; doing so may result in damage. [. . . ]