User manual YAMAHA PSS590

[. . . ] · A C-R/PHONES jack offers easy connection to a sub amp for monitoring. It allows monitoring of the main stereo output, TAPE IN input and the signals from groups 1/2, 3/4. · The mixer is equipped with a highly efficient, built-in digital effects section. The built-in effects allow you to create professional sounding mixes without the need of additional equipment. [. . . ] · Do not remove the unit's cover. If you think internal inspection, maintenance, or repair is necessary, contact your dealer. Doing so is a fire and electrical shock hazard. · If lightning begins to occur, turn off the power switch of the unit as soon as possible, and unplug the power cable plug from the electrical outlet. · If there is a possibility of lightning, do not touch the power cable plug if it is still connected. Doing so may be an electrical shock hazard. Cautions · Hold the power cord plug when disconnecting it from an AC outlet. A damaged power cord is a potential fire and electrical shock hazard. · Do not touch the power plug with wet hands. Doing so is a potential electrical shock hazard. Operating Notes · Using a mobile telephone near this unit may induce noise. If noise occurs, use the telephone away from the unit. · XLR-type connectors are wired as follows: pin 1: ground, pin 2: hot (+), and pin 3: cold (-). NOTE: It is not possible to simultaneously use both the phone type and RCA pin type jacks for an individual input channel. Please use only one or the other jack. e ST OUT (L, R) Jacks Balanced XLR type output jacks with a nominal output/impedance of +4dB/600. These jacks deliver stereo output of the mixed signal and are connected to a power amplifier, etc. The outputs can also be used for recording with the level of the signal controlled by the ST Master Fader. r MONO OUT Jack Balanced XLR type output jack with a nominal output/impedance of +4dB/600. This signal is the monaural mix of the STEREO bus's stereo signal. Its level is controlled with the MONO control. t C-R/PHONES Jack Stereo phone type output jack for connecting a set of headphones (nominal output/impedance of 3mW/40). It can also be used as a stereo phone type output jack for connecting a monitor system (nominal output/impedance of +4dB/10k). The source that is monitored with this jack is selected with the C-R/PHONES Output and Meter Select Switch (Master Control Section). NOTE: When this jack is connected to a monitor system, an insertion cable (optional YAMAHA insertion cable YIC025/050/070, etc. ) may be used. (Tip:L, Ring:R, Sleeve:Ground) MX12/6, 20/6 -- Owner's Manual Front & Rear Panels 7 Rear Panel w i u y t r e q q INSERT I/O Jack (MX12/6:CH1-4, MX20/6:CH1-8) These are input/output jacks that are positioned between the equalizer and fader of the input channel. They have a nominal input/impedance of 0dB/ 600 and a nominal output/impedance of 0dB/ 10k. [. . . ] w Connect a computer's audio card's LINE IN jack to the GROUP 3, 4 jacks and connect a pair of powered speakers, etc. e Connect the computer's LINE OUT jack to the stereo INPUT channel jack. r Use the GAIN Control to adjust the level of the input signal from the tone generator, synthesizer, microphone, etc. that is connected to each input channel (refer to page 2), and use the Channel Fader to adjust the level of the output signal that is sent to the Master Section. [. . . ]