User manual YAMAHA RHP80-100-120-120SD

[. . . ] · To clean the product, please wipe with a soft cloth or a damp cloth that has been wrung out thoroughly. If the product is soiled, use a neutral detergent on a cloth then wipe with a damp cloth that has been wrung out thoroughly to remove any remaining detergent. Do not use benzine, thinner or alcohol as it may result in discoloration or deformation. Also pay close attention so as not to let the water and detergent come into contact with the cushions used in the product, it may result in deterioration. [. . . ] Also, if the Real Head Pad is connected to an INPUT number on the DTX/DTXPRESS that is not capable of producing rim shots, the sound will not be produced. (Refer to the "Connections" section above. ) If the level is set too low, the signal level sent when the pad is hit will be very low so, the DTXTREME/DTX/DTXPRESS will not be able to produce sufficient volume from this low level signal. If the drum head is too loose, the output from the rim sensor may be reduced. Use a tuning key to adjust the tension on the head. (Refer to the previous "Setting Up" section. ) I Replacing the Cushion For sensing and sound deadening purposes, the Real Head Pads utilize a cushion that provides support to the entire drum head from within the pad. You can use the supplied corrugated cushion in place of the cushion that was installed at the factory. Use of the corrugated cushion offers a firmer feeling head. Select the best cushion according to the type of drum head you use. NOTE : When you use the corrugated cushion, put the yellow cushion that was installed at the factory on the bottom, then the corrugated cushion on top with the corrugated side of the cushion in contact with the drum head (in this case the flat, gray cushion is not needed). NOTE : When the corrugated cushion is not used, make sure the other cushions are positioned in the same manner as when the unit was shipped from the factory, with the flat, gray cushion on the bottom and the yellow cushion in contact with the drum head. If the cushions are reversed, it may result in deterioration of the cushions. When the corrugated cushion is not used. (As shipped from the factory) Gray Flat Cushion (Bottom) Yellow Cushion (Top) Is the drum head on the real head pad too loose?Is the DTXTREME/DTX/DTXPRESS properly connected to a pair of headphones or the external audio device?For more information, please refer to the "Owner's Manual" supplied with your DTXTREME/ DTX/DTXPRESS. If the Output LEVEL is set too high, the dynamic range may be reduced, or problems such as double triggers (when a single stroke produces multiply triggered sounds), and cross talk (hitting the pad causes the sound assigned to the rim to be produced or vice versa) may occur. : Do not put excessive pressure on the level adjustment knob, it may result in damage. LEVEL Adjustment Knob LE VE PA D RIM L Tom Holder Insert Rod Clamp (RHP120SD) The snare drum pad can setup on a snare drum stand (YAMAHA: SS642, etc. ) in the same manner as a normal snare drum. NOTE : When attaching the Real Head Pads to a rack system, we recommend that either the YAMAHA Rack System RS100 or RS95 be used. Using a ball clamp type tom holder like the RS100 allows the attachment of large pads like the RHP120. A cylinder type tom holder like the RS95 allows the attachment of lighter pads up to the RHP80-100-120-120SD-100-120-120SD. When a large pad such as the RHP100/120 is attached to the RS95, we recommend that the tom holder TPCL100 (optional) be used. The RS60 and RS80 may not provide adequate support for the Real Head Pads. If you already own the RS80 rack LE G About Rim Shot Sensitivity The locations of the RHP80-100-120-120SD-100-120-120SD/100/120/120SD's trigger sensors are shown in the illustration. The highest sensitivity can be found in the direct vicinity of the sensor and will decrease as you move away from the sensor. If you are going to use rim shots, we recommend that the area of highest sensitivity be placed in an optimum position when setting up the pad. I Connections Use the supplied stereo phone cable to connect the pad's output jack to the input (SNARE, TOM1, etc. ) of the DTXTREME/DTX/DTXPRESS. Connect the cable's L-shaped plug to the pad. NOTE : The RHP80-100-120-120SD-100-120-120SD/100/120/120SD Real Head Pads are dual trigger type electronic drum pads. [. . . ] Mismatches or incorrect installation may result in overheating and battery case rupture. Warning: Do not attempt to disassemble, or incinerate any battery. Dispose of used batteries promptly and as regulated by the laws in your area. Note: Check with any retailer of household type batteries in your area for battery disposal information. [. . . ]