User manual YAMAHA RS-80

[. . . ] Electronic Drum Rack System RS-80 I RS-80 Rack Stand Parts * Before assembling the rack stand, make sure all of the parts shown below are included. A Left Side Assembly (x1) B Right Side Arm (x1) Assembly Instructions Thank you for purchasing the Yamaha Electronic Drum Rack System RS-80. [. . . ] Above the Center Bar E , attach the Center Pipe D , and tighten the fixing bolts. Attach the Center Pipe D 5 Attach the Drum Pad Clamps 5-1 Insert the Hex Rod Cylinders H into the Drum Pad Clamps I J , and tighten the fixing bolts. 5-2 Attach the Drum Pad Clamps (Short) I to the snare drum and floor tom positions. The Drum Pad Clams (Long) J should be attached to the hihat and tom tom positions. 5-3 Insert the Hex Rod Cylinders H in the pads, adjust the position of the pad and tighten the fixing bolts. Tighten Step Tighten Center Bar Tighten Tighten E 3 2 Step 6 Attach the Cymbal Holders 6-1 Insert the Cymbal Holders K into the Cymbal Holder Clamps that are attach to the left and right sides of the Center Pipe D , and tighten all fixing bolts. 6-2 Attach the Cymbal Pad to the Cymbal Holders K , adjust the position and tighten the fixing bolts. (Refer to the Cymbal Pad's Owner's Manual for instructions on attaching the cymbal pad to the cymbal holder. ) Step 1 Right Side Arm B Step 6-2 Left Side Assembly A Right Side Assembly C 4 Attach the Module Holder 4-1 Insert the Hex Rod Cylinder H into the Module Holder Clamp G , and tighten the fixing bolts. Step Cymbal Pad 5-1 4-2 Attach the Module Holder Clamp G to the Left Side Assembly A pipe. [. . . ] To keep cable out of the way while playing, use the supplied Cable Bands to hold the cables to the rack systems's pipes. [. . . ]