User manual YAMAHA RS502

[. . . ] The rack may overturn or be damaged, resulting in injury. If this symbol is ignored and the equipment is used improperly, there is a danger or injury to persons handling the equipment, and material damage could occur. CAUTION • Watch your fingers when adjusting clamps. They may become pinched, resulting in injury. [. . . ] Take the right leg from the package and insert it into clamp t. When inserted, ensure that the right leg protrudes from the clamp by approximately 7 cm. 7 cm Right leg Bolt Clamp t Right arm 12. Securely tighten the bolt on clamp t. RS502 Owner’s Manual 7 13. Lift up the main frame and open up the left arm, the right arm, and the snare arm. Left arm Right arm Snare arm CAUTION Do not open up the rack’s left and right legs any more than shown in the figure below. Failure to observe this precaution can lead to the rack toppling over and causing injury. 130° 130° 1, 100 mm 14. Securely tighten the bolts on clamps q, w, and e. Clamp q Clamp w Bolt Bolt Clamp e Bolt 15. Check all bolts and screws once again and ensure that they are tightly fastened. 8 RS502 Owner’s Manual Attaching the Holders 1. Loosen the bolts on the following seven clamps (A to G) and rotate or move the clamps to the positions shown below. Following this, securely tighten all of the bolts to lock the clamps in place. • One snare clamp (A) • Three tom clamps (B, C, and D) • Two cymbal clamps (E and F) • One drum module clamp (G) Tom clamps (x3) E G B A C F Drum module clamp D Snare clamp Cymbal clamps (x2) NOTE Tom clamp D should be moved but not rotated. (All other clamps are rotated. ) RS502 Owner’s Manual 9 2. Attach a tom holder to each of the three tom clamps. CAUTION Take special care with tom holders as they have sharp tips that could cause injury. Tom holder Bolt Tom clamp 2-1. Securely tighten the bolt on the tom clamp. Attach a cymbal holder to each of the two cymbal clamps.  On the left arm  On the right arm Cymbal holder Cymbal holder Sleeve (black) Sleeve (black) Bolt Bolt Cymbal clamp Cymbal clamp 3-1. Securely tighten the bolt on the cymbal clamp. NOTE When tightening the bolt, ensure that the black sleeve is positioned inside the clamp’s mounting hole and securely held. 10 RS502 Owner’s Manual 4. Attach the snare holder to the snare clamp. CAUTION Take special care with the snare holder as the rod has a sharp tip that could cause injury. Snare holder Snare clamp Bolt 4-1. Securely tighten the bolt on the snare clamp. If going on to assemble a Yamaha electronic drum kit, please refer to the Assembly Manual booklet that came with your pad set. Troubleshooting  The rack is unstable even though placed on a level surface. Check whether the arrow stickers are lined up with the slits in the clamps. (See Step 4 and Step 8 of Assembling the Rack on pages 6 and 7, respectively. ) If they are not, loosen each of the clamp bolts, adjust the arms to align the arrow stickers with the slits, and then retighten the bolts. Specifications Size (assembled): 1, 196 (w) × 528. 3 (d) × 812. 3 (h) mm Weight: 8. 3 kg *: Specifications and descriptions in this Owner’s Manual are for information purposes only. [. . . ] Wettergrens Gata 1, Box 30053 S-400 43 Göteborg, Sweden Tel: 031 89 34 00 ARGENTINA Yamaha Music Latin America, S. A. Sucursal de Argentina Olga Cossettini 1553, Piso 4 Norte Madero Este-C1107CEK Buenos Aires, Argentina Tel: 011-4119-7000 MALAYSIA Yamaha Music (Malaysia) Sdn. , Bhd. Lot 8, Jalan Perbandaran, 47301 Kelana Jaya, Petaling Jaya, Selangor, Malaysia Tel: 03-78030900 DENMARK Yamaha Music Europe GmbH, Tyskland – filial Denmark Generatorvej 6A, DK-2730 Herlev, Denmark Tel: 44 92 49 00 PANAMA AND OTHER LATIN AMERICAN COUNTRIES/ CARIBBEAN COUNTRIES Yamaha Music Latin America, S. A. [. . . ]