User manual YAMAHA RS85A ASSEMBLY MANUAL

[. . . ] The pad may drop, the rack or pipes may slip, pinching or causing injury to hands or fingers. Please be careful when children are close to or touching the product. Since the product has many pipes and arms, careless movement around the product may result in injury. When setting the pads and modules, please pay close attention in regards to the handling and setting of cables. [. . . ] Please be careful when children are close to or touching the product. Since the product has many pipes and arms, careless movement around the product may result in injury. When setting the pads and modules, please pay close attention in regards to the handling and setting of cables. Carelessly placed cables may cause the user and others to trip and fall. Doing so may result in injury or damage/deterioration to the product. If this symbol is ignored and the equipment is used improperly, there is a danger or injury to persons handling the equipment, and material damage could occur. Do not put your hands or feet under the foot pedal or foot switch. Watch your fingers when adjusting clamps. They may become pinched, resulting in injury. Be careful around pipe ends, inside the pipe and screw ends. Clamps may be damaged and drums may drop, causing injury. Do not step on or place heavy objects on the product. Do not use or keep the product in places with extremely high temperature (places in direct sunlight, close to a heater, in a closed car, etc. ) or high humidity (bathroom, outside on a rainy day, etc. Doing so may result in deformation, discoloration, stickiness, damage or deterioration. * Remove the RS85A unit and the accessories from the box and follow the instructions described below to complete the assembly. After removing the unit from the box, remove all cushion material. Loosen the wing bolts (A and B), slide the leg base pipes (D) out for about 7 cm, and attach the rubber feet (C) to the pipes. attaching the Satellite Speakers of the Electronic Drum Kit Monitor System (sold separately) , etc. May result in the rack in being heavily weighted to the backside and off-balance. To prevent this from happening, make sure that after you attach the rubber feet (C), there is at least 3 cm gap between the rubber feet (C) and the clamps of the wing bolts (A), as shown in Fig. Loosen the bolts on the movable arms and legs, as shown in the diagrams below, then secure the bolts firmly once setting is complete. [. . . ] Do not put your hands or feet under the foot pedal or foot switch. Watch your fingers when adjusting clamps. They may become pinched, resulting in injury. Be careful around pipe ends, inside the pipe and screw ends. [. . . ]