User manual YAMAHA RX-500/U

[. . . ] The exclamation point within an equilateral triangle is intended to alert you to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. 10 Power Sources ­ The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the unit. 11 Power-Cord Protection ­ Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the unit. 12 Cleaning ­ The unit should be cleaned only as recommended by the manufacturer. 13 Nonuse Periods ­ The power cord of the unit should be unplugged from the outlet when left unused for a long period of time. [. . . ] If so, it can be re-stored by simply following the preset tuning procedure. or 2 Select the preset station number. Front panel Remote control or 34 English AUTOMATIC PRESET TUNING (for FM stations only) You can also make use of the automatic preset tuning function for FM stations only. This function enables the unit to perform automatic tuning and to sequentially store FM stations with strong signals. Up to 40 stations can be stored automatically in the same way as that for manual preset tuning on page 33. Note that a new setting can be stored in place of the former one. 31 24 To store stations 1 Select the FM band. Front panel 4 To tune in to higher frequencies, press the UP side of TUNING once. To tune in to lower frequencies, press the DOWN side of TUNING once. Front panel 2 Press TUNING MODE so that the "AUTO TUNING" indicator lights up on the display. Front panel * If TUNING is not pressed, the automatic preset tuning soon begins automatically toward higher frequencies. Automatic preset tuning begins from the frequency currently displayed. Received stations are sequentially stored as A1, A2 . . . * If more than 8 stations are received, they are stored as the preset station numbers in other groups (B, C, D and E) in that order. Lights up 3 Press MEMORY and hold for about three seconds. Front panel Flashes If you want to store the first station received by automatic preset tuning as a desired preset station number For example, if you want to store the first received station as C5, select "C5" while "A1", the "MEMORY" indicator and the "AUTO TUNING" indicator flash after pressing MEMORY in step 3. The first received station is stored as C5, and the next stations as C6, C7 . . . If stations have been stored up to E8, automatic preset tuning automatically stops. When automatic preset tuning is complete The display shows the frequency of the last preset station. Check the contents and the number of preset stations by following the procedure in the section "To recall a preset station" on page 34. 35 Notes · You can manually replace a preset station with another FM or AM station by simply following the procedure in the section "To store stations" on page 33. 2 DOLBY PRO LOGIC ENHANCED ( ) This functions when the input signal is analog or PCM audio, or encoded with Dolby Digital in 2-channel. Speaker output: main, center, rear DOLBY DIGITAL ENHANCED ( ) This functions when the input signal is encoded with Dolby Digital (not in 2-channel). Speaker output: main, center, rear 3 70 mm MOVIE THEATER ( ) This functions when the input signal is analog or PCM audio, or encoded with Dolby Digital in 2-channel. Speaker output: main, center, rear DIGITAL MOVIE THEATER ( ) This functions when the input signal is encoded with Dolby Digital (not in 2-channel). Speaker output: main, center, rear This reproduces video discs, video tapes and similar sources which are Dolby Surround encoded and bear the "DOLBY SURROUND" logo. This program ideally simulates the multi-surround speaker systems of the 35 mm film theater. Dolby Surround decoding is precisely performed without altering the original sound orientation. The surround effects produced by this sound field fold around the viewer naturally from the rear to the left and right and toward the screen. This is ideal for reproducing video discs, video tapes and similar sources which are Dolby Surround encoded and bear the "DOLBY SURROUND" logo. This program is ideal for precisely reproducing the sound design of the newest 70 mm/Dolby Digital multi-track films. The sound field is similar to that of the newest movie theaters, so the reverberations of the sound field itself are restrained as much as possible. The three-dimensional feeling of the sound field is emphasized, and dialog is precisely oriented on the screen. [. . . ] 260 W/340 VA Maximum Power Consumption 5 ch, 10% THD [General model only] . . . . . . . . . . . . . . . . . . . . . . . . . 630 W AC Outlets 2 SWITCHED OUTLETS [U. S. A. , Canada, Singapore, China and General models] . . . . . . . . . . . . . total 1 SWITCHED OUTLET [Australia model] . . . . . . . . . . . . . . . . . . . . Dimensions (W x H x D) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]