User manual YAMAHA RX-V4600

[. . . ] GB RX-V4600 AV Receiver Ampli-tuner audio-vidéo OWNER'S MANUAL MODE D'EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING MANUALE DI ISTRUZIONI MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. 1 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. 2 Install this sound system in a well ventilated, cool, dry, clean place ­ away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. Allow ventilation space of at least 30 cm on the top, 20 cm on the left and right, and 20 cm on the back of this unit. [. . . ] · Select "Surround Back" to use surround back speakers when a surround back channel signal is detected in a CINEMA DSP program. Presence channel signals will be output from front speakers. Select Manual Setup, then press h. Select Basic, then press h. 3 Sound Basic Option Test Tone Speaker Set Speaker Distance Speaker Level 4 y Select the desired parameters, then press h to access and adjust. · Most of the parameters described in the basic menu are set automatically when you run auto setup. You can use the basic menu to make further adjustments, but we recommend running auto setup first. · You can reset these parameters by performing the auto setup procedure (see page 27). 62 SYSTEM OPTIONS Test Tone (Test tone) Turns the test tone output on or off for Speaker Set, Speaker Distance and Speaker Level settings. Manual Setup > Basic > Test Tone > Choices: Off, On Center (Center speaker) Choices: Large, Small, None Front Center Surround Surround Back Large Small None Test Tone Speaker Set Speaker Distance Off On y · If you use a handheld SPL meter, hold at arms length and point upwards so that the meter is in the listening position. With the meter set to the 70 dB scale and to C SLOW, calibrate each speaker to 75 dB. · This menu item is also available in the front panel display system options menu (see page 89). · Select "Large" if you have a large center speaker. The unit directs the entire range of the center channel signal to the center speaker. · Select "Small" if you have a small center speaker. The unit directs the low-frequency signals of the center channel to the speakers selected with Bass Out. · Select "None" if you do not have a center speaker. The unit directs all of the center channel signal to the front left and right speakers. Surround (Surround left/right speakers) Choices: Large, Small, None Front Center Surround Surround Back Presence Large Small None Note Loud test tones will be output when "On" is selected. In this case, make sure no children are present in the listening room. Speaker Set (Speaker set) Use to manually adjust any speaker setting. Manual Setup > Basic > Speaker Set > Choices: Front, Center, Surround, Surround Back, Presence, Bass Out, Bass Cross Over, SWFR Phase y If you are not satisfied with the bass sounds from your speakers, you can change these settings according to your preference. Note Set any THX speakers to Small. Front (Front speakers) Choices: Large, Small Large Front Center Surround Small · Select "Large" if you have large surround left and right speakers or if a rear subwoofer is connected to the surround speakers. The entire range of the surround channel signal is directed to the surround left and right speakers. · Select "Small" if you have small surround left and right speakers. The low-frequency signals of the surround channel are directed to the speakers selected with Bass Out. · Select "None" if you do not have surround speakers. This sets the unit to the Virtual CINEMA DSP mode (see page 39) and automatically sets the surround back speaker setting (Surround Back) to "None". ADVANCED OPERATION · Select "Large" if you have large front speakers. The unit directs the entire range of the front left and right channel signals to the front left and right speakers. [. . . ] AC 110/120/220/230­240 V, 50/60 Hz [Asia model] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 220/230­240 V, 50/60 Hz [China model] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 220 V, 50 Hz [Korea model] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 220 V, 60 Hz [Australia model] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . and Europe models] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]