User manual YAMAHA RX-V492RDS

[. . . ] RXV492RDS RXV392RDS Natural Sound AV Receiver Récepteur audiovisuel "Son Naturel" Natural Sound AV-Receiver Natural Sound AV-receiver Sintonizzatore AV a suono naturale Receptor AV de Sonido Natural Natural Sound AV Ontvanger OWNER'S MANUAL MODE D'EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING MANUALE DI ISTRUZIONI MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING SUPPLIED ACCESSORIES ACCESSOIRES FOURNIS MITGELIEFERTE ZUBEHÖRTEILE MEDFÖLJANDE TILLBEHÖR ACCESSORI IN DOTAZIONE ACCESORIOS INCLUIDOS BIJGELEVERDE ACCESSOIRES Indoor FM Antenna Antenne FM intérieure UKW-Innenantenne FM inomhusantenn Antenna FM interna Antena FM interior FM Binnenantenne q q q q q q q After unpacking, check that the following parts are included. Après le déballage, vérifier que les pièces suivantes sont incluses. Nach dem Auspacken überprüfen, ob die folgenden Teile vorhanden sind. Kontrollera efter det apparaten packats upp att följande delar finns med. [. . . ] (For detailed information on the tuning operations, refer to the page 26. ) VOLUME l6 20 l2 TV/DBS DVD/LD TAPE (MD) MONITOR 28 8 PHONO CD TUNER PHONO 40 4 60 2 0 ­dB Note The settings of DSP and the VOLUME, BASS, TREBLE and BALANCE controls have no effect on the material being recorded. 24 English Selecting the SPEAKER system Because one or two speaker systems (as main speakers) can be connected to this unit, the SPEAKERS switches allow you to select speaker system A or B, or both at once. SPEAKERS A B Adjusting the BASS and TREBLE controls BASS 0 l 2 3 4 5 5 2 3 4 5 5 TREBLE 0 l l 2 3 4 l 2 3 4 ON OFF BASS : Turn this clockwise to increase (or counterclockwise to decrease) the low frequency response. Adjusting the BALANCE control Adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance caused by speaker location or listening room conditions. BALANCE 0 l l 2 3 4 L5 2 3 4 5R TREBLE : Turn this clockwise to increase (or counterclockwise to decrease) the high frequency response. Note These controls are effective only for the sound from the main speakers. Note This control is effective only for the sound from the main speakers. 25 TUNING OPERATIONS Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is possible. However, if signals of the station you want to select are weak, you must tune to it manually (MANUAL TUNING). l6 20 l2 28 8 40 4 60 2 0 ­dB 1 AUTOMATIC TUNING 32 1 Select the reception band (FM or AM) confirming it on the display. FM/AM MANUAL TUNING 1 Select the reception band (FM or AM) confirming it on the display. FM/AM or or 2 TUNING MODE AUTO/MAN'L MONO 2 AUTO TUNING MODE AUTO/MAN'L MONO Turn "AUTO" off. 3 DOWN TUNING UP 3 Tune to a desired station manually. DOWN TUNING UP To tune to a higher frequency, press the right side once. To tune to a lower frequency, press the left side once. * If the station where tuning search stops is not the desired one, press again. * If the tuning search does not stop at the desired station (because the signals of the station are weak), change to the MANUAL TUNING method. * To continue tuning search, press and hold the button. Notes · If you tune to an FM station manually, it is received in monaural mode automatically to increase the signal quality. · When tuned in to a station, the frequency of the received station is shown on the display. If an RDS station that employs PS data service is received, the frequency is then replaced by the station name. Refer to page 32 for details. 26 English PRESET TUNING MANUAL PRESET TUNING This unit can store station frequencies selected by tuning operation. With this function, you can recall any desired station by only selecting the preset station number where it is stored. Up to 40 stations (8 stations x 5 groups) can be stored. l6 20 l2 28 8 40 4 60 2 0 ­dB 2, 1 4, 2 To store stations 3 To recall a preset station 1 2 Tune to a desired station. (Refer to the previous page for tuning procedure. ) 1 Select the group of preset stations. A/B/C/D/E Select a desired group (A ­ E) of preset stations confirming it on the display. A/B/C/D/E PRESET 2 Select the preset station number. 1 2 3 4 5 6 7 8 3 MEMORY MEMORY MAN'L/AUTO FM Flashes on and off for about 5 seconds. 4 Select a preset station number where you want to program the station before "MEMORY" goes off from the display. 1 2 3 4 5 6 7 8 Notes A new setting can be programmed in place of the former one. · For presets, the setting of the reception mode (stereo or monaural) is stored along with the station frequency. · PRESET STEREO MHz AUTO 0 20 l00 Memory back-up The memory back-up circuit prevents the programmed data from being lost even if the POWER switch is set off or the power plug is disconnected from the AC outlet or the power is cut due to temporary power failure. If, however, the power is cut for more than one week, the memory may be erased. If so, it can be re-programmed by simply following the PRESET TUNING steps. CONCERT HALL Shows the displayed station has been programmed to A1. * In the same way, program other stations to A2, A3 . . . * You can program more stations to preset station numbers on other groups in the same way by selecting other groups in step 2. 27 AUTOMATIC PRESET TUNING You can also make use of an automatic preset tuning function for RDS stations only. By this function, this unit performs automatic tuning and stores RDS stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as in the manual preset tuning method on page 27. * Refer to page 30­34 for details on RDS stations. l6 20 l2 28 8 40 4 60 2 0 ­dB To store stations 1 23 When the automatic preset tuning is finished The display shows the frequency of the last preset station. Check the contents and the number of preset stations by following the procedure of the section "To recall a preset station" on page 27. 1 FM/AM To recall a preset station 2 MEMORY PRESET MAN'L/AUTO FM Simply follow the procedure of the section "To recall a preset station" on page 27. * A recalled station is shown by the frequency or station name on the display. [. . . ] A desired station cannot be tuned in with the automatic tuning method. AM FM There are continuous crackling and hissing noises. There are buzzing and whining noises (especially in the evening). Noises will result from ligtning, fluorescent lamps, motors, thermostats and other electrical equipment. Direct sunlight or lighting (of an inverter type of flourescent lamp etc. ) is striking the remote control sensor of the main unit. The batteries of this remote control transmitter are too weak. Remote control transmitter The remote control transmitter does not work. Replace the batteries with new ones. [. . . ]