User manual YAMAHA S112PHIII

[. . . ] Stable placement will also ensure better sound performance. Placing the speaker on the same shelf or rack as the turntable can result in feedback. Deutsch Never put a hand or a foreign object into the port located on the rear of the speaker as this might cause personal injury and/or damage to the speaker. When moving the speaker, do not hold the port as it might cause personal injury and/or damage to the speaker. Any time you note distortion, reduce the volume control on your amplifier to a lower setting. [. . . ] Do not attempt to modify or fix the speaker. Contact qualified YAMAHA service personnel when any service is needed. The cabinet should never be opened for any reasons. Secure placement or installation is the owner's responsibility. YAMAHA shall not be liable for any accident caused by improper placement or installation of the speaker. · · Español · · · · · · · · PRECAUTIONS WHEN POSITIONING THE SPEAKERS The speaker is constructed with the majority of the weight located in its upper portion, and is thus susceptible to falling over if proper care is not taken to insure its stability. If the speaker falls over, it may damage the speaker or be the cause of injury (or even death) to persons and/or damage to personal property. Vibrations or jolts associated with earthquakes and other phenomena or activities may cause the speaker to fall over. For safety reasons, using commercially available products that increase stability in the speaker is recommended (metal fittings or chains, etc. ). Use the stands included with the speaker to increase stability: Be sure to use the stands regardless of where the speaker is positioned. Attaching the stands included with the speaker reinforces the base of the speaker not to fall over. Please be cautioned that even though the stands are connected, this does not guarantee that the speaker will not fall over. For safe and proper use of the speaker: · Position the speaker in a location that is solid, level, smooth, and low (with respect to the floor). Note: · Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both of them. · Do not insert the insulation coating into the hole. The sound may not be produced. Amplifier or Receiver E-3 <Bi-wired connections> Remove the short bars before connecting. Tweeter terminals Red (+) Black (­) Short bars Bi-Wired Connections This speaker system is capable of bi-wired connections. To connect the speaker to the output terminals of the amplifier (or receiver), two pairs of cables for each of mid-range/woofer and tweeter used instead of standard connections. This type of connection decreases the modulation distortion caused by electric resistance of the cables and driving current of the speakers. Consequently, purer sound quality can be expected. To utilize bi-wired connections, remove the short bars from the terminals first, and then connect the mid-range/woofer and tweeter to the amplifier separately using two pairs of cables. Mid-range/woofer terminals S112PHIII(R) S112PHIII(L) S112PHIII(R) S112PHIII(L) SPEAKERS SPEAKERS R L R L A + + ­ ­ + ­ ­ + B Amplifier or Receiver Amplifier or Receiver Both SPEAKERS A and B should be selected. When using a banana plug Banana plug 3 1 1 2 3 Remove the cover by pulling it toward you. Simply insert the banana plug into the terminal. 2 E-4 PLACING THE SPEAKERS Using as 2ch stereo speakers Better stereo images will be obtained when the speakers are slightly angled in towards the listeners. English REMOVING THE FRONT COVER The front cover is fastened to the enclosure at six points and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the six holes on the inner surface of the cover with the six corresponding pegs on the speaker and push gently. Using as front speakers in a multi channel system Position the speakers on both sides of the TV. [. . . ] Set up the speakers on the basis of your listening position by following the owner's manual supplied with your amplifier. Note: When the cover is removed, take care not to touch the speaker units with your hands or to exert excessive force with tools. S112PHIII Subwoofer SPECIFICATIONS Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-way bass reflex speaker system Magnetic shielding type Driver . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 cm (6. 5") cone woofer x 1 16 cm (6. 5") mid-range x 1 3 cm (1") dome tweeter Surround back Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Frequency Response . . . . . . . . . . . . . . . . . . . [. . . ]