User manual YAMAHA S4115H

[. . . ] Cable/s supplied with this product MUST be used. Failure to follow instructions could void your FCC authorization to use this product in the USA. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. [. . . ] [­] transposes down, [+] transposes up, and [0] resets the transposition value to 00. r [TEMPO] buttons Used to change the playback tempo. [­] decreases the tempo, [+] increases the tempo, and [0] resets the tempo to 00. t [VOLUME] buttons Used to adjust the volume. [­] lowers the volume, [+] raises the volume. 1 2 5 8 3 DRIVE 2 4 7 6 9 TRANSPOSE 0 TEMPO 0 0 3 4 5 6 REPEAT ­ A-B + e r t ­ REV·FWD + VOLUME ­ + SONG SELECT PLAY PAUSE STOP 7 PPR-102E 9 8 1 [RECORD] button Used to engage the Record Standby mode before recording starts. 2 Number keypad* Used for direct song selection and to enter a start time for song playback. 3 [REPEAT] button* Used to select one of the Repeat functions: ALL, RPT, or RND. 4 [A-B] button* Used to enter A and B points for Segments A~B and A~ Repeat modes. 5 [REV. FWD] buttons In Play mode: Used to fast preview and review. In Pause mode: Used to fast forward and reverse. * Available on the remote control, but not on the Control Unit. 10 Chapter 3 Disks Used with the Disklavier English Three types of disks are used with the Disklavier: floppy disks, CDs, and internal Memory Disks. Chapter 3: Disks Used with the Disklavier Floppy Disks Besides PianoSoft and PianoSoft. Plus song disks, the Disklavier can play back songs stored on 3. 5inch MS-DOS 720 Kbyte format 2DD floppy disks and MS-DOS 1. 44 Mbyte format 2HD floppy disks. Accidental Erasure Protection Floppy disks have an erasure protection tab which can be set so that the Disklavier cannot record new data onto the disk. This is useful for protecting valuable song data against accidental erasure and disk formatting. (See Chapter 2 "Chain Play -- Playing Back Memory Disks in a Group" and Chapter 3 "Timer Play" in the Advanced Operation Manual for details. ) See also Chapter 1 "Storing & Managing Songs on Disks" in the Advanced Operation Manual for more information on using Memory Disks. English Chapter 3: Disks Used with the Disklavier SELECT DRIVE UNIT CONTROL DKC55RCD GENERAL INSTRUMENT REC E PLAY/PAUS STOP SONG EV ¥ FWD SELECT/R ENTER FUNC. METRONOME ¥¥ VOLUME TEMPO E TRANSPOS BALANCE ¥ --10 --4 --2 --8 --6 +/YES 0 --/NO VOICE PART R L STANDBY ON Note: Always place the CD with the label side facing up. Then, gently push the tray back in until it clicks into place. SELECT DRIVE ROL UNIT CONT DKC55RCD GENERAL INSTRUMENT REC E PLAY/PAUS STOP SONG EV ¥ FWD SELECT/R ENTER FUNC. OMETR NOME ¥¥ VOLUME TEMPO E TRANSPOS BALANCE ¥ --10 --4 --2 --8 --6 +/YES 0 --/NO VOICE PART R L STANDBY ON 13 Chapter 4 Turning On/Off Your Disklavier This chapter describes how to turn on and off your Disklavier and how to set the internal calendar. Turning your Disklavier on/off is a basic and very important procedure. Always be sure to follow the procedure described below when you turn on or off your Disklavier. Turning On the Disklavier 1 Set the MAINS switch to ON. Turning Off the Disklavier 1 Press [STANDBY / ON] on the Control Unit. 2 MAINS ON OFF Set the MAINS switch to OFF. Setting the MAINS switch to OFF is effectively the same as disconnecting the power cable from an AC wall outlet. If the Disklavier is used regularly, you only need to use the [STANDBY / ON] button on the Control Unit. If the Disklavier is not going to be used for a long period, set the MAINS switch to OFF. When the Disklavier is turned off, wait at least 5 seconds before turning it on again. Note: The MAINS switch only needs to be switched off when you are not going to use the Disklavier for a long period of time. For daily use, only the [STANDBY / ON] button on the Control Unit needs to be turned on and off. 2 Press [STANDBY / ON] on the front panel of the Control Unit. DRIVE SELECT CONTRO L UNI T DKC 55RCD PLAY/P GENER AUSE AL INSTRUMENT STOP REC SONG SELECT /REV ¥ FWD STANDB Y ON ENTER L PART R VOICE FUN The following message appears on the display. Your Disklavier is now ready for use. 14 Setting the Internal Calendar The Disklavier has an internal calendar that can be set from 1/1/1985 00:00:00 to 12/31/2084 23:59:59. Set the calendar accurately so that the Disklavier displays the correct current time during Stop mode. Setting the correct time is also important for engaging timer-controlled programs (see Chapter 3 "Timer Play" in the Advanced Operation Manual for details). [. . . ] See "Formatting Disks" on page 17 in the Advanced Operation Manual. 7 When you finish playing your song, press [STOP]. When [STOP] is pressed, the following display appears. 2b Use the [SELECT] buttons to select the number of the memory disk that will serve as the recording destination. 3 Press [REC] to engage the Record Standby mode. The REC indicator lights and the PLAY/PAUSE indicator flashes. A new song number is created for the new recording. For example, if the last song to be recorded was No. 6, then the new song will be No. 7. The following table gives a description of each of options. Option SAVE NEW Description The new recording is saved under the current song number. [. . . ]