User manual YAMAHA SILENT BRASS PICKUP MUTE

[. . . ] * With the exception of the owner's manual, each attachment can be ordered separately. 11 Pickup Mute Specifications Pickup Mute PM9 PM7 PM6 PM5 PM3 PM2 PM1 Instrument Piccolo Trumpet Trumpet, Cornet Flugelhorn, Alto Trombone Trombone, Bass Trombone French horn Euphonium Tuba 190 x 410 mm (7-1/2" x 16-1/8") 380 x 980 mm (14-15/16" x 38-9/16") 108 x 270 mm (4-1/4" x 10-5/8") Dimensions (diameter x length) 70 x 145 mm (2-3/4" x 5-11/16") 70 x 200 mm (2-3/4" x 7-7/8") Maximum hand rest -- -- -- -- 150mm 220mm 420mm Weight width 80g (2. 8oz. ) 120g (4. 2oz. ) 270g (9. 5oz. ) 300g (10. 5oz. ) 800g (1lbs. , 12oz. ) 2900g (6Ibs. , 6oz. ) Common specifications for all models: Internal Microphone: Electric condenser microphone, Nominal Level: -25dB to -35dB, Material: ABS resin * Specifications and design are subject to change without notice. 12 Your Pickup Mute will give you years of reliable service if you follow the simple rules given below: Location Do not expose it to the following conditions to avoid deformation, discoloration, or more serious damage. near a heat source, out side, or in a car during the daytime). [. . . ] · Always unplug cables by gripping the plug firmly, not by pulling on the cable. · Disconnect all cables before moving the unit. · Physical shocks caused by dropping, bumping, or placing heavy objects on the unit can result in scratches and more serious damage. Cleaning · Clean the cabinet and panel with a dry soft cloth. · A slightly damp cloth may be used to remove stubborn grime and dirt. · Never use cleaners such as alcohol or thinner. YAMAHA is not responsible for damage caused by improper handling or operation. 92-BP 13 Set up and Use Personal Studio ST7 Connecting Cable PICKUP MUTE 1 2 PHONES 1 2 Stereo Earphone PM7 for TRUMPET PM6 for FLUGELHORN Lock Nut PM5 for TROMBONE Hand Rest (P. 17) PM3 for FRENCH HORN PM2 for EUPHONIUM Handle 14 Before connecting the cable and attaching the mute, make sure the power is switched OFF and the earphones are removed from your ears. PICKUP MUTE 1 2 PHONES 1 2 Stereo Earphone Head Connecting Cable Handle Body Lock Nut Assembling the PM1 1. Inner Head Lay the Head on the floor. hook 2. Place the Body on the Head and fasten with the three hooks. 3. Fully extend the Inner Head that is located in the center of the Head. PM1 for TUBA * Refer to pg. 16 for instructions on attaching the mute to the instrument. 15 QUICK GUIDE Attaching and removing the pickup mute Attach the Pickup Mute to the Tuba As shown in the illustration, hold the instrument with your left hand and, while turning the pickup mute, firmly insert it into the bell with your right hand. 1. For Euphoniums, with the bell facing up, hold the PM2 by its handle in your right hand and firmly insert it into the bell. After assembling the Pickup Mute (refer to pg. While seated, hold the tuba between your legs. Hold the Pickup Mute by its handle and lift it up. 2. Holding the Pickup Mute with both hands, gently insert the Inner Head into the bell of the tuba. (Continue holding the tuba between your legs. ) 3. Adjust the Pickup Mute so that it is positioned in the center of the bell. [. . . ] Clean any moisture on the PICKUP MUTE with a cloth. DO NOT WASH WITH WATER. 17 QUICK GUIDE Insert firmly Signal path REHEARSAL ROOM CONCERT HALL CHURCH REVERB MODE From PHONES 1 Tighten the Lock Nut Connect the supplied cable to the PICKUP MUTE output jack and tighten the LOCK NUT. AUX IN REVERB LEVEL PLAYER 2 MASTER VOLUME PLAYER 1 To PICKUP MUTE 1 Don't step on the cable * Personal Studio ST7 and stereo earphone are not included. Disconnecting the cable while the power is ON may result in damage to the unit. [. . . ]