User manual YAMAHA SPX2000 EDITOR

[. . . ] Editor Owner's Manual Special Notices · The software and this owner's manual are the exclusive copyrights of Yamaha Corporation. · Copying of the software or reproduction of this manual in whole or in part by any means is expressly forbidden without the written consent of the manufacturer. · Copying of the commercially available music sequence data and/or digital audio files is strictly prohibited except for your personal use. · Yamaha makes no representations or warranties with regard to the use of the software and documentation and cannot be held responsible for the results of the use of this manual and the software. [. . . ] Therefore, this section does not display the SPX2000 unit's correct setting. ) Bank select buttons ![STORE] button Click one of the [PRESET/CLASSIC/USER] buttons to see the effects that are stored in the corresponding bank. This button stores the current settings into the selected effect (location). This button is used to recall the selected effect. Appendix NOTE @ [RECALL] button If you recall an effect from the FILE section of the Library window, the display background color in the SPX2000 unit and the LCD color in SPX2000 Editor may differ. In this case, copy the effect into the INTERNAL DATA section, and then recall it. # [CLEAR] button $ [UNDO] button This button clears the selected effect from the list. This button undoes the last recall, store, copy, clear, sort, titling, protect or color select operation. Note: In the Library window, you can undo only the most recent operation. You cannot undo any operations performed prior to the most recent operation. % LCD color select This lets you change the background color of the SPX2000 unit's display for each effect that is recalled. You can change the background color only for USER bank effects. You can choose one of five colors. ^ [PROTECT] button This button is used to protect or unprotect the selected effect. 6 SPX2000 Editor Owner's Manual Using SPX2000 Editor Windows Getting Started Effect Editor Window The Effect Editor window lets you edit effect parameters. . To open the Effect Editor window, choose [Effect Editor] from the [Windows] menu. 1 2 3 4 5 6 7 8 1 Effect select section 9 ) 2 [COMPARE] button/indicator The [COMPARE] button will light when you edit a parameter after recalling an effect. To compare the result of your editing with the un-edited effect settings, click the lit [COMPARE] button. Its layout depends on the selected effect type. This knob enables you to adjust the balance between the wet and dry signals. When set to 0, only the dry signal is heard. When set to 100, only the wet signal is heard. This button is used to bypass the currently selected effects processor. This window is displayed only if the FREEZE/FREEZE A/ FREEZE B effect type is selected. To begin recording (sampling), click the REC button and then click the PLAY button. The progress bar lets you to check the currently recording position. To play back the recorded sample, click the PLAY button. Using SPX2000 Editor Windows Appendix Getting Started 5 [IN] button 6 [OUT] button 7 Level Meters 8 Effect parameter section 9 [MIX BALANCE] knob ) [BYPASS] button ! [. . . ] The reverberation duration of the high frequency range is expressed as a ratio relative to Reverb Time. Length of reverberation in the low frequency range. The reverberation duration of the low frequency range is expressed as a ratio relative to Reverb Time. Frequency value that serves as the basis for the Lo Ratio value. [. . . ]