User manual YAMAHA TDM850-2000

[. . . ] OWNER'S MANUAL TDM850 4TX-28199-E4 EAU00001 INTRODUCTION Welcome to the Yamaha world of motorcycling!As the owner of a TDM850, you are benefiting from Yamaha's vast experience in and newest technology for the design and the manufacture of high-quality products, which have earned Yamaha a reputation for dependability. Please take the time to read this manual thoroughly, so as to enjoy all your TDM850's advantages. The owner's manual does not only instruct you in how to operate, inspect and maintain your motorcycle, but also in how to safeguard yourself and others from trouble and injury. [. . . ] You may use soft water if you can't get distilled water. @ @ PERIODIC MAINTENANCE AND MINOR REPAIR NOTE: q If water is added, have a Yamaha dealer check the antifreeze content of the coolant as soon as possible. q The radiator fan operation is completely automatic. It is switched on or off according to the coolant temperature in the radiator. @ @ 5. If your motorcycle overheats, see page 6-34 for details. 1. Cylinder drain bolt Changing the coolant 6 1. (See page 6-5 for cowling removal and installation procedures. ) 3. Remove the radiator cap stopper bolt and radiator cap. EW000067 5. Remove the water pump drain bolt and cylinder drain bolt. WARNING Do not remove the radiator cap when the engine is hot. @ @ 6-11 PERIODIC MAINTENANCE AND MINOR REPAIR 11. Drain the coolant completely and thoroughly flush the cooling system with clean tap water. If the washers are damaged, replace them. Tighten the water pump drain bolt and cylinder drain bolt to the specified torques. Tightening torque: Water pump and cylinder drain bolts: 10 Nm (1. 0 m·kg) 13. Pour the recommended coolant into the radiator until it is full. Recommended antifreeze: High quality ethylene glycol antifreeze containing corrosion inhibitors for aluminum engines. Antifreeze and water mixing ratio: 1:1 Total amount: 1. 7 L Coolant reservoir capacity: 0. 3 L 6-12 ECA00041 CAUTION: Hard water or salt water is harmful to the engine. You may use soft water if you can't get distilled water. @ @ 1. 4. Coolant reservoir Bolt Coolant reservoir hose clamp Hose 6. (See page 3-12 for seat removal and installation procedures. ) 7. Remove the coolant reservoir by removing the bolts. Remove the coolant reservoir hose clamp and disconnect the hose. Drain the coolant from the coolant reservoir by turning it upside down. Install the hose and connect the coolant reservoir hose clamp. 14. [. . . ] 3-12 Shifting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-4 Shift pedal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-8 Sidestand . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-17 Sidestand/clutch switch operation check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]