User manual YAMAHA TDM900-2007

[. . . ] OWNER'S MANUAL TDM900 5PS-28199-E5 EAU26943 DECLARATION of CONFORMITY We Company: MORIC CO. , LTD. Address: 1450-6 Mori Mori-Machi Shuchi-gun Shizuoka 437-0292 Japan Hereby declare that the product: Kind of equipment: IMMOBILIZER Type-designation: 5SL-00 is in compliance with following norm(s) or documents: R&TTE Directive(1999/5/EC) EN300 330-2 v1. 1. 1(2001-6), EN60950-1(2001) Two or Three-Wheel Motor Vehicles Directive(97/24/EC: Chapter 8, EMC) Place of issue: Shizuoka, Japan Date of issue: 1 Aug. Contents To change contact person and integrate type-designation. 1 Version up the norm of EN60950 to EN60950-1 2 Date 9 Jun. [. . . ] Install the seat and the cowling. 1 1. Panel A 6-6 PERIODIC MAINTENANCE AND MINOR REPAIR EAU19830 Specified spark plug: NGK/DPR8EA-9 DENSO/X24EPR-U9 Tightening torque: Spark plug: 17. 5 Nm (1. 75 m·kgf, 12. 7 ft·lbf) Engine oil and oil filter element The engine oil level should be checked before each ride. In addition, the oil must be changed and the oil filter element replaced at the intervals specified in the periodic maintenance and lubrication chart. Place the vehicle on a level surface and hold it in an upright position. NOTE: Make sure that the vehicle is positioned straight up when checking the oil level. A slight tilt to the side can result in a false reading. Start the engine, warm it up for 15 minutes, and then turn it off. Wait a few minutes until the oil settles, remove the oil filler cap, wipe the dipstick clean, insert it back into the oil filler hole (without screwing it in and with the arrow mark pointing upward as shown), and then remove it again to check Before installing a spark plug, the spark plug gap should be measured with a wire thickness gauge and, if necessary, adjusted to specification. NOTE: If a torque wrench is not available when installing a spark plug, a good estimate of the correct torque is 1/4­1/2 turn past finger tight. However, the spark plug should be tightened to the specified torque as soon as possible. 2 3 4 5 6 7 8 9 1 1. Spark plug gap Spark plug gap: 0. 8­0. 9 mm (0. 031­0. 035 in) Clean the surface of the spark plug gasket and its mating surface, and then wipe off any grime from the spark plug threads. 6-7 PERIODIC MAINTENANCE AND MINOR REPAIR the oil level. NOTE: The engine oil should be between the minimum and maximum level marks. 1 2 3 4 1 2 3 4 5 4. If the engine oil is below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level. NOTE: G The engine oil tank is located behind the cylinders. G The engine oil should be between the minimum and maximum level marks. To change the engine oil (with or without oil filter element replacement) 1. Start the engine, warm it up for several minutes, and then turn it off. Place an oil pan under the engine to collect the used oil. Remove the engine oil filler cap and drain bolts to drain the oil from the crankcase. 1 1. Minimum level mark ECA10010 6 7 8 9 CAUTION: Do not operate the vehicle until you know that the engine oil level is sufficient. EWA10360 WARNING Never remove the engine oil tank cap after high-speed operation, otherwise hot engine oil could spout out and cause damage or injury. Always let the engine oil cool down sufficiently before removing the oil tank cap. 6-8 PERIODIC MAINTENANCE AND MINOR REPAIR 1 2 2 installing the bolts, then tightening them to the specified torque. Tightening torque: Oil filter element cover bolt: 10 Nm (1. 0 m·kgf, 7. 2 ft·lbf) 1 1. Bolt NOTE: Make sure that the O-rings are properly seated. Install the engine oil drain bolts, and then tighten them to the specified torques. Tightening torques: Engine oil drain bolt A: 35 Nm (3. 5 m·kgf, 25 ft·lbf) Engine oil drain bolt B: 30 Nm (3. 0 m·kgf, 21. 7 ft·lbf) 2 3 4 5 6 7 8 9 NOTE: Skip steps 4­6 if the oil filter element is not being replaced. [. . . ] 6-28 Storage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-3 Storage compartment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-14 Supporting the motorcycle. . . . . . . . . . . . . . . . . . . . . . . 6-34 C Cables, checking and lubricating . . . . . . . . . . . . [. . . ]