User manual YAMAHA TDR125-2001

[. . . ] OWNER'S MANUAL TDR125 5AE-28199-E4 EAU03338 INTRODUCTION Welcome to the Yamaha world of motorcycling!As the owner of a TDR125, you are benefiting from Yamaha's vast experience and newest technology regarding the design and manufacture of high-quality products, which have earned Yamaha a reputation for dependability. Please take the time to read this manual thoroughly, so as to enjoy all advantages of your TDR125. The owner's manual does not only instruct you in how to operate, inspect and maintain your motorcycle, but also in how to safeguard yourself and others from trouble and injury. [. . . ] Remove the coolant drain bolt and disconnect the hose on the side of the reservoir to drain the reservoir. After the coolant is completely drained, thoroughly flush the cooling system with clean tap water. Install the coolant drain bolt, and then tighten it to the specified torque. Never attempt to remove the radiator cap when the engine is hot. 6-11 PERIODIC MAINTENANCE AND MINOR REPAIR 10. Pour the recommended coolant into the radiator until it is full. cC EC000080 1 Antifreeze/water mixture ratio: 1:1 Recommended antifreeze: High-quality ethylene glycol antifreeze containing corrosion inhibitors for aluminum engines Coolant quantity: Total amount: 1. 05 L Coolant reservoir capacity: 0. 35 L 1. Hose NOTE: Check the washer for damage and replace it if necessary. Tightening torque: Coolant drain bolt: 8 Nm (0. 8 m0kg) 9. Install the reservoir tank hose. 8 If coolant is not available, use distilled water or soft tap water instead. Do not use hard water or salt water since it is harmful to the engine. 8 If water has been used instead of coolant, replace it with coolant as soon as possible, otherwise the engine may not be sufficiently cooled and the cooling system will not be protected against frost and corrosion. 8 If water has been added to the coolant, have a Yamaha dealer check the antifreeze content of the coolant as soon as possible, otherwise the effectiveness of the coolant will be reduced. Install the radiator cap, start the engine, let it idle for several minutes, and then turn it off. 1 2 3 4 5 6 7 8 9 6-12 PERIODIC MAINTENANCE AND MINOR REPAIR 1 2 3 4 5 14. Start the engine, and then check the vehicle for coolant leakage. If coolant is leaking, have a Yamaha dealer check the cooling system. Install the cowling, radiator cover and seat. 1 2 3 4 5 6 7 8 9 1. 5. 1 Coolant reservoir tank cap Stopper Screw Maximum level mark Minimum level mark 1. Bolt EAU03747 Cleaning the air filter element The air filter element should be cleaned at the intervals specified in the periodic maintenance and lubrication chart. Clean the air filter element more frequently if you are riding in unusually wet or dusty areas. (See page 3-12 for seat removal and installation procedures. ) 2. (See page 6-6 for cowling removal and installation procedures. ) 3. Remove the radiator cap to check the coolant level in the radiator. If necessary, add sufficient coolant until it reaches the top of the radiator, and then install the radiator cap. Check the coolant level in the reservoir. [. . . ] (This will coat the cylinder wall with oil. ) e. Remove the spark plug cap from the spark plug, and then install the spark plug and the spark plug cap. cC ECA00014 7 8 Storing the motorcycle in a poorly ventilated room or covering it with a tarp, while it is still wet, will allow water and humidity to seep in and cause rust. 8 To prevent corrosion, avoid damp cellars, stables (because of the presence of ammonia) and areas where strong chemicals are stored. w EWA00003 To prevent damage or injury from sparking, make sure to ground the spark plug electrodes while turning the engine over. 7-4 MOTORCYCLE CARE AND STORAGE 6. Lubricate all control cables and the pivoting points of all levers and pedals as well as of the sidestand/centerstand. [. . . ]