User manual YAMAHA TMXE

[. . . ] Before using your Glockenspiel Stand, carefully read and follow the precautions below. Make sure that the YGS100A's slide leg fixing bolts or lower crossbar fixing bolts are firmly tightened once the stand is set at the desired height. [. . . ] Bolts left loose may cause the stand's height to shift during performance and can also cause noise and other problems. When adjusting the height of the YGS70, make sure that the gear's teeth are aligned then close the lever to securely lock the gears in place. Using the stand when the gears are loose and not locked securely may cause the instrument and stand to drop and serious injury. Use or storage in the following locations may cause damage, even when packaged. â· In direct sunlight, such as near a window, or in a closed vehicle in daytime. Near heating devices or in other locations subject to excessive heat. Locations where the instrument can be exposed to rain or moisture. Utilizing a gear system on this X-type glockenspiel stand provides quick and easy, one-touch height adjustment. Simply use the lever located on the center section to adjust the height. Since the YGS70 uses an X-type leg design, adjusting the height will result in a change in the width of the stand, which will have an effect on the size of instrument that can be set on the stand, so please use caution. For safety reasons, assembly should be performed by at least two persons. E Connect the Left and Right legs with the lower crossbar support. Insert the lower crossbar support with its notch facing up into the joints on both legs and firmly tighten the wing bolts. Align the legs from above so that the slide legs will slide into the corresponding leg holes. [. . . ] Insert the lower crossbar support with its notch facing up into the joints on both legs and firmly tighten the wing bolts. Align the legs from above so that the slide legs will slide into the corresponding leg holes. [. . . ]