User manual YAMAHA UX256E

[. . . ] Owner's Manual Bedienungsanleitung Mode d'emploi Français Deutsch USB-MIDI INTERFACE English SPECIAL MESSAGE SECTION This product utilizes batteries or an external power supply (adapter). DO NOT connect this product to any power supply or adapter other than one described in the manual, on the name plate, or specifically recommended by Yamaha. Battery Notice: This product MAY contain a small non-rechargeable battery which (if applicable) is soldered in place. The average life span of this type of battery is approximately five years. When replacement becomes necessary, contact a qualified service representative to perform the replacement. [. . . ] Make sure the power to the UX256s is turned off (standby). Connect the USB terminal of the computer or the USB hub to the USB terminal on the UX256s using the USB cables. Turn on the power to the UX256s. NOTE When you turn on the power to connected multiple UX256s, the device number is assigned, starting with 0, to the units in the order in which you turn on the power. If you turn on the power to all units simultaneously, the device number is assigned based on the order of the port numbers of the USB hub. However, this order may change depending on the hub. 17 Installing the Driver Installing the driver on a Macintosh system First install OMS before you install the driver. Also, after installing the driver, you will need to set up OMS (page 20). (1) Installing OMS 1. Insert the included CD-ROM into the CD-ROM drive. The system displays the CD-ROM icon on the desktop. Double-click the CD-ROM icon and double-click the "Install OMS 2. 3. 6" icon in the "OMS" folder. Follow the instructions on the screen to install OMS. For more information on installing and using OMS, refer to the included "OMS_2. 3_Mac. pdf" manual. (2) Installing the USB driver 1. Insert the included CD-ROM into the CD-ROM drive. Double-click the CD-ROM icon and double-click the "Install USB Driver" icon to display the following installation screen. 18 Installing the Driver 4. The "Install Location" box displays the destination of the installation. If you wish to change the destination disk or folder, use the [Switch Disk] button and the pop-up menu to specify the desired destination. NOTE This box usually displays the start-up disk as the destination. 5. The system displays the following message: "This installation requires your computer to restart after installing this software. Click Continue to automatically quit all other running applications. " Click [Continue]. 6. If the driver has already been installed, you will receive the following message. To complete the installation, click [Quit]. 7. When the installation is complete, the system displays the following message: "Installation was successful. You have installed software which requires you to restart your computer. " Click [Restart]. The computer automatically restarts. You can locate the installed files in the following locations: · System Folder | Control Panels | YAMAHA USB MIDI Patch · System Folder | Extensions | USB YAMAHA MIDI Driver · System Folder | OMS Folder | YAMAHA USB MIDI OMS Driver 19 Installing the Driver (3) Setting up the OMS driver 1. Make sure that the power to the UX256 is turned off (standby). [. . . ] Rebouças 2636, São Paulo, Brasil Tel: 011-853-1377 DENMARK YS Copenhagen Liaison Office Generatorvej 8B DK-2730 Herlev, Denmark Tel: 44 92 49 00 PHILIPPINES Yupangco Music Corporation 339 Gil J. Box 885 MCPO, Makati, Metro Manila, Philippines Tel: 819-7551 ARGENTINA Yamaha Music Argentina S. A. Viamonte 1145 Piso2-B 1053, Buenos Aires, Argentina Tel: 1-371-7021 FINLAND F-Musiikki Oy Kluuvikatu 6, P. O. Box 260, SF-00101 Helsinki, Finland Tel: 09 618511 SINGAPORE Yamaha Music Asia Pte. , Ltd. [. . . ]