User manual YAMAHA V STAR CLASSIC-2004

[. . . ] OWNER'S MANUAL XVS650S XVS650AS XVS650ATS LIT-11626-17-26 5FB-28199-13 EAU10041 INTRODUCTION EAU10080 Congratulations on your purchase of the Yamaha XVS650/XVS650A/XVS650AT. This model is the result of Yamaha's vast experience in the production of fine sporting, touring, and pacesetting racing machines. It represents the high degree of craftsmanship and reliability that have made Yamaha a leader in these fields. This manual will give you an understanding of the operation, inspection, and basic maintenance of this motorcycle. [. . . ] Wait a few minutes until the oil settles, and then check the oil level through the check window located at the bottom-left side of the crankcase. NOTE: The engine oil should be between the minimum and maximum level marks. 2. Place an oil pan under the engine to collect the used oil. Remove the engine oil filler cap and drain bolt to drain the oil from the crankcase. 1. 4. Engine oil level check window Maximum level mark Minimum level mark Engine oil filler cap 1. If the engine oil is below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level. To change the engine oil (with or without oil filter element replacement) 1. Start the engine, warm it up for several minutes, and then turn it off. 6-11 NOTE: Skip steps 4­7 if the oil filter element is not being replaced. Remove the outer and inner oil filter element covers by removing the bolts. PERIODIC MAINTENANCE AND MINOR REPAIR Recommended engine oil: See page 8-1. Oil quantity: Without oil filter element replacement: 2. 60 L (2. 75 US qt) (2. 29 Imp. qt) With oil filter element replacement: 2. 80 L (2. 96 US qt) (2. 46 Imp. qt) ECA11620 1. Install a new oil filter element and the O-ring. Install the oil filter element covers by installing the bolts. Install the engine oil drain bolt, and then tighten it to the specified torque. Tightening torque: Engine oil drain bolt: 43 Nm (4. 3 m·kgf, 31 ft·lbf) G 1. Bolt In order to prevent clutch slippage (since the engine oil also lubricates the clutch), do not mix any chemical additives. Do not use oils with a diesel specification of "CD" or oils of a higher quality than specified. In addition, do not use oils labeled "ENERGY CONSERVING II" or higher. Make sure that no foreign material enters the crankcase. 6 5. Remove the oil filter element and O-ring. 9. Add the specified amount of the recommended oil, and then install and tighten the oil filler cap. 10. Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, immediately turn the engine off and check for the cause. 6-12 PERIODIC MAINTENANCE AND MINOR REPAIR 11. Turn the engine off, and then check the oil level and correct it if necessary. EAU20020 Final gear oil The final gear case must be checked for oil leakage before each ride. If any leakage is found, have a Yamaha dealer check and repair the vehicle. [. . . ] 3-2 Turn signal light bulb or tail/brake light bulb, replacing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-32 Turn signal switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-3 D Dimmer switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-3 E Engine break-in. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-4 Engine oil and oil filter element . . . . . . . . . . . . . [. . . ]