User manual YAMAHA VENTURE 500-2001

[. . . ] È. ) 2 The engine number is stamped in the location as shown. Ê. ) Also, record and keep the ID numbers in a separate place in case the snowmobile is stolen. ESU00011 2- INTRODUCTION Congratulations on your purchase of a Yamaha snowmobile. This model is the result of Yamaha's vast experience in the production of fine sporting and touring snowmobiles. It represents the high degree of craftsmanship and reliability that have made Yamaha a leader in these fields. [. . . ] Marginal snow The drive track and the slide runners are lubricated and cooled by snow and water. To prevent the drive track and slide runners from overheating, avoid sustained highspeed usage in areas such as icy trails, frozen lakes and rivers that have minimal snow coverage. An overheated track will be weakened internally, which may cause failure or damage. Off-trail riding Avoid off-trail riding until there is sufficient snow coverage. It generally takes several feet of snow to provide a good overall base to properly cover debris, such as rocks, logs, etc. If snow coverage is not sufficient, stay on trails to avoid impact damage to the drive track. Studded track In general, track life will be shortened when studs are installed. Drilling stud holes into the drive track will cut the internal fibers, which weakens the track. Studs may catch on an object and pull out of the track, leaving tears and damage around the already weakened area. To minimize possible damage, consult your stud manufacturer for installation and stud pattern recommendations. Yamaha does not recommend track studding. 7-9 ESU00245 Strap For SXV70M The strap 1 should be used only by experienced operators to assist them when traverse (side-hill) riding. WARNING @ Improper use of the strap on the handlebar can result in severe injury or death. 1 "OFF" È SXV70M/SXV70S É SXV70ER/VT70 WARNING @ G G Push down the engine stop switch to stop the engine in an emergency. Make sure that the key is removed from the main switch whenever the operator leaves the snowmobile, to prevent accidental starting. @ 7-12 ESU00138 Transporting When transporting your snowmobile on a trailer or in a truck, observe the following recommendations to help protect it from damage: G G G Make sure that the fuel level in the fuel tank is lower than the bottom of the carburetors. Otherwise, the vibration and bumps from the road surface could make it possible for fuel to flow through the carburetors into the crankcase. This can result in "hydrostatic lock, " a condition where the engine cannot rotate because of fuel accumulated in the engine. Severe engine damage can result from hydrostatic lock. When possible, the fuel tank should be empty during transportation, especially if the trip will be longer than 30 minutes. If transporting the snowmobile in an open trailer or truck, put a tight fitting cover on the snowmobile. A cover specifically designed for your snowmobile is best. This will help keep foreign objects out of the cooling vents in the shroud, and also help protect the snowmobile against damage from debris on the road. If transporting the snowmobile in an open trailer or truck in areas where road salt is used, coat metal suspension surfaces lightly with oil or other protectant. This will help protect against corrosion. [. . . ] Use Yamaha Stor-Rite Engine Fogging Oil, or an equivalent fogging oil, to protect both the com- bustion chamber and crankshaft from corrosion. An alternate method is to remove the carburetor silencer and squirt oil into the carburetor throats while the engine is running. CAUTION: @ Do not attempt to store the snowmobile by simply starting the engine occasionally during the storage period. Moisture and acids form during combustion which can actually increase the chance for corrosion damage during the storage period. @ 5. Protection Apply a coat of wax to painted surfaces. [. . . ]