User manual YAMAHA VX-35B

[. . . ] Retain this Owner's Manual in a safe place for future reference. 13 14 Read these instructions. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] · When Auto Power Off has been activated so that the projector is in standby mode, the power will not turn back on again even if an image signal is input once more. Press the [STANDBY/ON] button on either the projector's control panel or the remote control to turn the power back on. This is an output signal for controlling external equipment. · While projection is in progress, a voltage of +12 V is output. · When "Auto" is selected, the trigger out signal turns ON and OFF in accordance with the illumination of the projector's lamp. When "External" is selected, the trigger out signal turns ON and OFF in accordance with control signals received via the RS-232C port. Sets the display language for messages and menus. on either the projector's control panel or the remote control, · Press the and select the language from the selection menu that appears. Resets all items in all menus to their default settings. on either the projector's control panel or the remote control · Press the to display the confirmation screen, and select "Yes". · To reset the "Image" menu settings to their default values, select "Reset" from the sub-menu. When turning off the projector, wait 2 minutes. After about 2 minutes, the cooling fan will stop. When the cooling fan stops, turn off the main power switch and then turn it back on again. When the main power switch is turned back on, the projector will return to its previous state, so press the [STANDBY/ON] button on either the remote control or the projector's control panel to turn it back on. If the lamp operating error happens again when the power is turned back on, remove the lamp and check if the lamp is broken. Then turn on the main power switch at the rear of the projector and press the [STANDBY/ON] button on either the remote control or the projector's control panel. If the indicators still show a problem, stop using the projector, turn off the main power switch, disconnect the power cord from the electrical outlet, and contact your dealer. p. 48 Red Red Lamp operating error p. 48 36 Indicator status Red Red Projector status High temperature inside projector (overheating) Problem and remedy The lamp will turn off automatically and projection will stop. Wait for about 5 minutes without operating the projector. After 5 minutes have elapsed, the projector's cooling fan will stop. When the cooling fan stops, turn off the main power switch and then turn it back on again. If the projector overheats, check the following two points. [. . . ] ( "Basic Operations" in OWNER'S MANUAL) Be sure to read "Caution" in OWNER'S MANUAL for details on safe handling when setting up the projector. Front projection Front/ceiling projection Rear projection using a translucent screen Rear projection onto a translucent screen with the projector installed to the ceiling * When installing to the ceiling or projecting from behind the screen, set the "Installation" command in the "Setup" menu to match the method of projection being used. ("Setup" menu in OWNER'S MANUAL) A special method of installation is required in order to suspend the projector from the ceiling. Please contact the place of purchase if you would like to use this installation method. 5 Turn off the power for both the projector and the video source before connecting them. If the power for either device is on at the time of connection, damage may result. [. . . ]