User manual YAMAHA WIRELESS DCP

[. . . ] Wireless DCP Owner’s Manual Introduction Thank you for downloading the Wireless DCP app for Yamaha Matrix Processor MTX-series. Wireless DCP allows these processors to be controlled remotely using smart devices such as the iPhone. In specific terms, it has been designed to allow users to control volumes and presets on MTX processors via a simple, intuitive graphical interface from anywhere within wireless range. The latest version of the firmware for MTX-series products can be downloaded from the following web site. [. . . ] Two smart devices running Wireless DCP can be connected to each MTX processor. (However, only one device can be logged into by an administrator password. ) 4. Connect the MTX processor to the LAN connector of the Wi-Fi access point. If you connect to a WAN (Internet) connector, the smart device will not be able to communicate properly with the MTX processor. Wireless DCP Owner’s Manual 8 3. Configuration 3. 3 Wireless DCP Tap the Wireless DCP app to launch it. The Select Device screen will be displayed. Device list MTX processors available for connection are displayed here. When you select one, the Enter Password screen will be displayed. DEMO button Tap DEMO on this screen to activate Offline Demo mode. In this mode, you can try out Wireless DCP functions and the user interface without performing any actual operations on the MTX processor. If you launch Wireless DCP with Auto-connect mode active, the app will automatically reconnect to the MTX processor it was most recently used with. You can use the Auto-connect switch to modify this setting. Refer to Section 3. 3. 3 Entering a Password for details. Wireless DCP Owner’s Manual 9 3. Configuration  3. 3. 1 Offline Demo Mode In Offline Demo mode, Wireless DCP disconnects from the MTX processor so you can try out the app’s functions and user interface without performing any actual operations. To activate this mode, tap DEMO on the Select Device screen. Controller pane Use this pane to try out the faders and buttons. Page button Tap to display the Select Page screen. Controller 1 and Controller 2 buttons Tap to switch the Controller pane’s display. Settings button Tap to display the Settings screen. Wireless DCP Owner’s Manual 10 3. Configuration  From Demo mode to Normal mode On the Settings screen, tap Select Device. . . Here, you can select the MTX processor to be controlled. When you do so, the Enter Password screen will be displayed. Wireless DCP Owner’s Manual 11 3. Configuration  3. 3. 2 Making Connections On the Select Device screen, tap the MTX processor to be controlled. When you select a processor, the Enter Password screen will be displayed. Information displayed Upper line: Device name (configured using MTX Editor) Lower line: Unit ID and model name Wireless DCP Owner’s Manual 12 3. Configuration  3. 3. 3 Entering a Password Enter a valid password to connect to the selected MTX processor. Reset button Tap to display the Reset Password screen. Cancel button Tap to return to the Select Device screen without entering a password. 1 Auto-connect switch Turn this switch on to connect automatically whenever the app is launched. 2  To enter a password 1. Tap the password field to display the onscreen keyboard. Tap Join to connect to the MTX processor. Upon connection, the Controller 1 pane will be displayed. NOTE Passwords take the form of a four-digit number, and none are set when the app is first launched. In this condition, it is possible to log into Wireless DCP without entering a password by simply tapping Join. It is important, therefore, to set passwords. [. . . ] This error message may also be displayed if the selected MTX processor is not turned on or is already connected to a different smart device. Wireless DCP Owner’s Manual 25 6. Troubleshooting  Connection has been lost The error message on the left will be displayed if the selected MTX processor is turned off or the smart device is moved out of Wi-Fi range. If connection is lost when the iOS device is locked, this message will be displayed when it is unlocked. In such a case, tap Reconnect to reconnect to the MTX processor, and continue controlling it. [. . . ]