User manual YAMAHA WR400F-2001

[. . . ] 2006 General manager of quality assurance div. representative name and signature MORIC CO. , LTD. 1450-6 Mori-machi Shuchi-gun Shizuoka 437-0292 JAPAN Telephone +81-538-85-0757 Facsimile +81-538-85-0456 URL:http://www. moric-jp. com INTRODUCTION EAU10100 Welcome to the Yamaha world of motorcycling!As the owner of the FZ6-NHG, you are benefiting from Yamaha's vast experience and newest technology regarding the design and manufacture of high-quality products, which have earned Yamaha a reputation for dependability. Please take the time to read this manual thoroughly, so as to enjoy all advantages of your FZ6-NHG. [. . . ] · Lubricate with lithium-soap-based grease. · Lubricate with lithium-soap-based grease. · Check operation and for oil leakage. · Check operation and shock absorber for oil leakage. · Adjust engine idling speed and synchronization. Every 50000 km Every 800 km and after washing the motorcycle or riding in the rain 13 Drive chain 14 * Steering bearings Every 20000 km 6 15 * Chassis fasteners 16 17 18 Brake and clutch lever pivot shafts Brake and shift pedal pivot shafts Sidestand 19 * Sidestand switch 20 * Front fork 21 * Shock absorber assembly 22 * Fuel injection 6-3 PERIODIC MAINTENANCE AND MINOR REPAIR ODOMETER READING (× 1000 km) NO. ITEM CHECK OR MAINTENANCE JOB 1 23 24 Engine oil Engine oil filter cartridge · Change. · Check oil level and vehicle for oil leakage. · Check coolant level and vehicle for coolant leakage. · Adjust the throttle cable free play if necessary. · Lubricate the throttle grip housing and cable. Place the vehicle on a level surface and hold it in an upright position. NOTE: Make sure that the vehicle is positioned straight up when checking the oil level. A slight tilt to the side can result in a false reading. Start the engine, warm it up for several minutes, and then turn it off. Wait a few minutes until the oil settles. 1. Spark plug gap 6 Spark plug gap: 0. 6­0. 7 mm (0. 024­0. 028 in) Clean the surface of the spark plug gasket and its mating surface, and then wipe off any grime from the spark plug threads. Tightening torque: Spark plug: 17. 5 Nm (1. 75 m·kgf, 12. 7 ft·lbf) 6-7 PERIODIC MAINTENANCE AND MINOR REPAIR 4. Remove the engine oil dipstick and wipe it clean, insert it back into the hole (without screwing it in), and then remove it again to check the oil level. 1. Insert and tighten the engine oil dipstick, and then install and tighten the oil filler cap. 1. Minimum level mark NOTE: Skip steps 4­6 if the oil filter cartridge is not being replaced. Remove the oil filter cartridge with an oil filter wrench. 6 NOTE: The engine oil should be between the minimum and maximum level marks. [. . . ] 6-19 Coolant . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-10 Coolant temperature warning light. . . . . . . . . . 3-4 K Key identification number. . . . . . . . . . . . . . . . . . . . . . . . 9-1 L License plate light bulb, replacing . . . . . . . . . 6-33 D Dimmer switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-13 Drive chain, cleaning and lubricating. . . . [. . . ]