User manual YAMAHA XV1600A-2001

[. . . ] XV1600A OWNER'S MANUAL EAU03338 INTRODUCTION Welcome to the Yamaha world of motorcycling!As the owner of a Yamaha Wild StarTM, you are benefiting from Yamaha's vast experience and newest technology regarding the design and manufacture of high-quality products, which have earned Yamaha a reputation for dependability. Please take the time to read this manual thoroughly, so as to enjoy all advantages of your Yamaha Wild Star's. The owner's manual does not only instruct you in how to operate, inspect and maintain your motorcycle, but also in how to safeguard yourself and others from trouble and injury. [. . . ] NOTE: An oil filter wrench is available at a Yamaha dealer. @ @ 6 8. Install the new oil filter cartridge, and then tighten it to the specified torque with a torque wrench. Tightening torque: Oil filter cartridge: 17 Nm (1. 7 m·kg) 6-10 PERIODIC MAINTENANCE AND MINOR REPAIR 9. Install the engine oil drain bolts, and then tighten them to the specified torque. Tightening torque: Engine oil drain bolt: 43 Nm (4. 3 m·kg) 10. Pour only 2. 5 L of the specified amount of recommended engine oil through the filler hole, insert the dipstick, and then tighten the oil filler cap. Start the engine, rev it several times, and then turn it off. Remove the engine oil filler cap, and then gradually fill the oil tank with the remaining oil quantity while regularly checking the oil level on the dipstick. Oil quantity: Without oil filter cartridge replacement: 3. 7 L With oil filter cartridge replacement: 4. 1 L Total amount (dry engine): 5. 0 L EC000072 13. Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, immediately turn the engine off and check for the cause. Turn the engine off, and then check the oil level and correct it if necessary. 6 @ CAUTION: q In order to prevent clutch slippage (since the engine oil also lubricates the clutch), do not mix any chemical additives with the oil or use oils of a higher grade than "CD". In addition, do not use oils labeled "ENERGY CONSERVING II" or higher. q Make sure that no foreign material enters the crankcase. @ 6-11 PERIODIC MAINTENANCE AND MINOR REPAIR NOTE: Make sure that the motorcycle is positioned straight up when checking the oil level. A slight tilt to the side can result in a false reading. @ @ 2. Remove the oil check bolt, and then check the oil level in the transfer case. 1. Transfer case oil check bolt EAU03395 Transfer case oil The transfer case oil level should be checked before each ride. In addition, the oil must be changed at the intervals specified in the periodic maintenance and lubrication chart. Place the motorcycle on a level surface and hold it in an upright position. NOTE: The oil should be at the brim of the check hole. @ @ 1. If the oil is below the brim of the check hole, remove the oil filler cap, add sufficient oil of the recommended type to raise it to the correct level, and then install the oil filler cap. Install the oil check bolt, and then tighten it to the specified torque. Tightening torque: Transfer case oil check bolt: 7. 5 Nm (0. 75 m·kg) To change the transfer case oil 1. [. . . ] 6-16 Ignition circuit cut-off system. . . . . . . . . . . . . . . . . . 3-16 Indicator and warning lights . . . . . . . . . . . . . . . . . . . . . 3-2 D Dimmer switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-6 Drive belt slack . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-26 Adjusting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-27 Checking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-26 K Key identification number . . . . . . . . . . . . . . . . . . . . . . . . 9-1 INDEX Starter (choke) knob . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]