User manual YAMAHA YAS-101

[. . . ] Fm Page 1 Friday, September 9, 2011 10:51 AM AVEEA71102B G Important Notice: Guarantee Information for customers in EEA* and Switzerland English For detailed guarantee information about this Yamaha product, and Pan-EEA* and Switzerland warranty service, please either visit the website address below (Printable file is available at our website) or contact the Yamaha representative office for your country. Com/warranty/ OWNER’S MANUAL MODE D’EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING MANUALE DI ISTRUZIONI MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING © 2011 Yamaha Corporation Printed in Malaysia ZA79070 Caution: Read this before operating your unit. 1 2 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. [. . . ] (+ increases the delay time) y To turn off the volume temporarily, press MUTE. To resume the volume, press MUTE again or press VOLUME +/–. Make the delay time longer Make the delay time shorter Adjust the subwoofer level Press SUBWOOFER +/– to adjust the bass level. The color of qD DTS indicator changes depending on the bass level. Green indicates a minus level, orange a standard level (default value is 0), and red a plus level. The color of qD DTS indicator changes depending on the adjustable range. Green indicates a shorter delay time, orange a medium delay, and red a longer delay. 3 Press AUDIO DELAY to exit the adjustment mode. Y The adjustment mode is canceled if the unit is left for 20 seconds without any operation being performed. Additional Information Using an external subwoofer Although the unit has a subwoofer built-in, you can use commercially available powered subwoofer of your choice. The SURROUND indicator (for 2 seconds after the unit is turned on) Built-in subwoofer External subwoofer 1 2 Set the unit to standby mode. Press both the VOLUME – button and button of the main unit, release the button first, then release the VOLUME – button. This unit is turned on when switching between the built-in subwoofer and external subwoofer. The SURROUND indicator lights up as the following illustration. € You can verify the current setting by turning the unit on again from standby mode. Note You cannot use the built-in subwoofer and the external subwoofer simultaneously. 8 En Additional Information Operation by the TV remote control is difficult (with unit beneath/under TV) TV remote control operation may be difficult if the unit hides the sensor of your TV when beneath or under the TV. Try the two solutions below and see whether this solves the problem. 2 English Press both the VOLUME + button and button of the main unit, release the button first, then release the VOLUME + button. The unit is turned on when switching the TV remote control signal transmission function on/off. The CLEAR VOICE indicator lights up as the following illustration. 11) On The CLEAR VOICE indicator (for 2 seconds after the unit is turned on) 1 Move the unit in all directions. [. . . ] The unit obstructs the 3D glasses transmitter of Check the position of 3D glasses transmitter of your TV. Your TV by referring to the manual of your TV, and move the unit to the position where there is no obstruction. The picture on your TV screen becomes blurred or distorted. € — Contact your nearest authorized Yamaha dealer or service center if the following problem occurs. [. . . ]