User manual YAMAHA YC45D

[. . . ] NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. Compliance with FCC regula* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. [. . . ] * To protect the speakers from possible damage, always set the OUTPUT e volume to "0" before turning the power ON/OFF. 8 Before making any connections, make sure that the power on the YC45D and any external devices is switched OFF. OUT YC45D internal speaker or a speaker with an impedance of 4-8 and can handle 100W or more. MIDI IN Store data from the YC45D's internal memory to a MIDI device. A MIDI Controller can be used to select memory and control volume. If necessary, you can disconnect the internal speaker and connect an external speaker to this jack. If an external speaker is used, make sure that the speaker meets the following requirements. Connect this jack to the MIDI IN jack of a device that can save MIDI data. the data stored in the YC45D's internal memory can then be transmitted to an external MIDI device for storage. ( page 11: MIDI Bulk Out) Also, transmits MIDI data received by the MIDI IN jack @0, to an external device when MIDI Merge is set to ON. An external effector can be inserted into the signal circuit between the SEND/RETURN jacks. Choose one of the YC45D's eight preset amp types, then use the GAIN+MASTER, and tone controls to shape the guitar's sound. Choose an amp type using one of the AMP SELECT buttons. Use the GAIN, MASTER, and the five tone controls to shape the guitar's sound. Volume levels for individual memory settings should be set with the MASTER knob. The speaker's output level should be controlled with the OUTPUT knob. * When an AMP SELECT button is pressed, all knobs (except TRIM, OUTPUT and REVERB) will return to their preset positions. With the procedures on this page, you can create an original sound (settings), and along with the reverb and echo settings they can be stored in the DG100212's internal memory for instant recall at anytime. The procedure for storing data in memory is explained on the next page. Each setting (sound) can be recalled at any time. motor drives in the knobs will automatically set the knobs to the corresponding positions. Create a sound and try storing it in memory. [. . . ] to exit from the Utility Mode , press the button , the "AMP" (amp mode) display lamp will light. * MIDI messages cannot be received when in the Utility Mode so, refer to the "MIDI Memory Recall", "MIDI Volume Control", "MIDI Reverb Echo ON/OFF" and "MIDI Bulk In" sections in this manual to perform the corresponding MIDI operations. With this procedure, a specific memory number in the YC45D's internal memory can be recalled with a program change number received from an external MIDI device. Using the / buttons, select the program change number (1 ­ 2. [. . . ]