User manual YORKVILLE CV-1

[. . . ] Only use attachments/accessories specified by the manufacturer Note: Prolonged use of headphones at a high volume may cause health damage on your ears. The apparatus should not be exposed to dripping or splashing water; no objects filled with liquids should be placed on the apparatus. Terminals marked with the "lightning bolt" are hazardous live; the external wiring connected to these terminals require installation by an instructed person or the use of ready made leads or cords. Ensure that proper ventilation is provided around the appliance. [. . . ] Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. No naked flame sources, such as lighted candles, should be placed on the apparatus. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. the AC supply cord should be routed so that it is unlikely that it will be damaged. Protect the power cord from being walked on or pinched particularly at plugs. if the AC supply cord is damaged DO NOT OPERATE THE UNIT. To completely disconnect this apparatus from the AC Mains, disconnect the power supply cord plug from the AC receptacle. The color fade speeds are fairly slow and are intended for gradually changing mood lighting. The chase speeds are faster and are multi color. It is necessary to connect to an internal circuit board with a jumper cable supplied with the DMX module. Operating instructions for the DMX mode are supplied with the DMX module. When operating with the Yorkville Sound LP-608 lighting controller the COLOR controls on the LPLED4 remain active. The COLOR control can be used to select the color of each fixture or if the COLOR control is set to off then the LP-608 intensity control becomes the color control (including off) but the intensity is not controllable. The automatic level circuitry allows it to be used with signals from weak line levels up to strong loudspeaker levels. Multiple CV-1 units may be linked with a standard 3-pin XLR cable. When the first unit in the chain is not receiving a control signal its controls are active and the downstream units operate identically to the first unit. The CV-1 will mount on a standard loudspeaker stand or C clamps can be fitted to any of the 4 threaded mounting points. Not only does the unit give off much less heat but also consumes less than 5% to 20% of the energy. [. . . ] Not only does the unit give off much less heat but also consumes less than 5% to 20% of the energy. This eliminates the need for separate AC power circuits just to run the lights. Power consumption is under 270 watts depending on color choice and intensity. The light fixtures and the base are fan cooled. [. . . ]