User manual YURAKU YUR.VISION YV216WB1 BROCHURE

[. . . ] Plug & Play Drivers for the YURAKU Series Monitors are available at: www. aocmonitor. com CHECKING THE CONTENTS OF THE MONITOR PACKAGE The product package should include the following items: 1. Swivel Base FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS) NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] It could short circuit parts causing a fire or electric shock. Do not attempt to service the monitor yourself; opening or removing covers can expose you to dangerous voltages and other hazards. Please refer all servicing to qualified service personnel. To ensure satisfactory operation, use the monitor only with UL listed computers which have appropriate configured receptacles marked between 100 - 240V AC, Min. The wall socket shall be installed near the equipment and shall be easily accessible. Attention: Disconnect the power cord to stop the power supply to the monitor. Plug & Play DDC1/2B Feature This monitor is equipped with VESA DDC1/2B capabilities according to the VESA DDC STANDARD. It allows the monitor to inform the host system of its identity and, depending on the level of DDC used, communicate additional information about its display capabilities. The communication channel is defined in two levels, DDC1 and DDC2B. The DDC1 is a unidirectional data channel from the display to the host that continuously transmits EDID information. The DDC2B is a bidirectional data channel based on the I²C protocol. The host can request EDID information over the DDC2B channel. The LED should either turn ON or OFF after hitting the CAPS LOCK key. Missing one of the primary colors (RED, GREEN, or BLUE) *Inspect the monitor's video cable and make sure that none of the pins are bent. INSTALLATION INSTRUCTIONS SWIVEL BASE To attach the swivel base to the monitor, do the following: · Carefully turn the monitor on its side or upside down. (see figure 1) · Locate the cavities at the bottom front of the monitor. · Insert the pegs on the swivel base into these cavities. Push the swivel base forward until the swivel base locks in place. · To remove the swivel base, hold the bottom of the swivel base, then push it out. Make sure the power cord is the correct type that required in your area. This monitor has a universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is required). Connect the power cord into your monitor's power input socket, and then plug the other end into a 3-pin AC power outlet. The power cord may be connected to either a wall power outlet or the power outlet socket on your PC, depending on the type of power cord supplied with your monitor. VIDEO CABLE Connecting the Video Cable: the monitor comes with a built-in video cable. [. . . ] Stubborn stains may be removed with a cloth lightly dampened with a mild detergent solution. Never use strong solvents such as thinner, benzene, or abrasive cleaners, since these will damage the cabinet. As a safety precaution, always unplug the monitor before cleaning it. Figure 1: Installing and Removing the Swivel Base Figure 2: Connecting Cables 1. 3. Signal Cable Power Cord VGA Card Connector Figure 3: External Controls 1. [. . . ]