User manual ZANKER KV314

[. . . ] ¥ Ice lollies can cause Ôfrost/freezer burnsÕ if consumed straight from the freezer. ¥ It is dangerous to try and alter the specifications or modify this product in any way. ¥ Under no circumstances should you attempt to repair the appliance yourself. Refer to your local Service Centre, and always insist on genuine spare parts. Environment Protection ¥ This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. [. . . ] Do not use detergents or abrasive powders, as these will damage the finish. ¥ Remove safety elements used for transportation. ¥ It allows you to adjust the temperature inside the refrigerator according to use and external conditions. ¥ Setting ã1Ò = hightest temperature, warmest setting ¥ Setting ã6Ò = lowest temperature, coldest setting. ¥ Setting ã0Ò = Off A medium setting is generally the most suitable. Internal Parts Storage shelves ¥ The shelves can be removed for cleaning. Starting the appliance ¥ Insert the plug into the wall socket and turn the thermostat knob clockwise beyond position ÇOÈ (OFF). ¥ Turn the thermostat control to the required setting. Temperature Control ¥ The thermostat control situated inside the fridge compartment regulates the temperature of the appliance. D040 10 ¥ To permit storage of food packages of various sizes, the shelves can be placed at different heights. ¥ To remove the internal shelf pull forward until it can be tipped up or down and removed. ¥ Please do the same in reverse to insert the shelf at a different height. The glass shelf above the vegetable drawers and the bottle shelf should always remain in position, to ensure correct air circulation. Door shelves ¥ To permit storage of food packages of various sizes, the central door shelf can be adjusted in height. ¥ Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. ¥ Do not place warm foods inside the appliance. ¥ Once defrosted, the refrigerator will start up again automatically; the defrosting water which has collected in the tray below the evaporator must however be removed. Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. Changing the light bulb ¥ Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb. ¥ The opening on the diffuser gives access to the light bulb. ¥ Replace the bulb by other with another with the same charcteristics. 12 Something not Working Problems may be due to causes which can easily be solved before calling the Technical Service. Please follow these instructions: SYMPTOM Door does not close SOLUTION Weight surpasses the storage limit of the door shelf so spread weight more evenly or take some products out. The appliance is not properly installed. Please look in the ÒBuilding-inÓ section. Distribute the food products to allow cold air to circulate around them. Make sure that the door is completely closed and that the insulating strip is complete and clean. The temperature where the cabinet is placed is above normal room temperature. [. . . ] Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. Important The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. [. . . ]