User manual ZANKER TT 160 A

[. . . ] GEBRUIKSAANWIJZING MODE D`EMPLOI GEBRAUCHSANLEITUNG INSTRUCTION BOOK KOELKAST REFRIGERATEUR KÜHLSCHRANK REFRIGERATOR TT 160 A (TTI 160 C) NL FR DE GB 1346963 H/Z/8-1. (02. ) GB Before installing and using the appliance read this user's instruction book carefully. It contains safety precautions, hints, information and ideas. If the refrigerator is used in compliance with the instructions written, it will operate properly and provide you with greatest satisfaction. [. . . ] The lack of light does not influence operation of the refrigerator. 50 GB If something does not work During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out. In the following chart information is given about them to avoid unnecessary charges on service. We draw your attention that operation of appliance goes with certain sounds (compressor- and circulating sound). This is not trouble, but means normal operation. Problem The appliance does not cool sufficiently Possible cause Thermostatic control is set too low. Too many foods to be cooled were put in. There is no inside cool air circulation. The thermostatic control is set too high. We draw it to your attention again that the appliance operates discontinuously, so the stopping of compressor does not mean being nocurrent. That is why you must not touch the electrical parts of the appliance before breaking the circuit. Solution Set higher position. Check if the appliance stands stable (all the four feet should be on the floor). The appliance cools too hard The appliance does not cool at all The appliance is noisy Plug is not connected to the mains socket properly. There is no voltage in the mains socket. The appliance is not supported properly. Inasmuch as the advice does not lead to result, call the nearest brand-mark service. Ins tr uctions f or the Ins t aller Technical data Model/Type Gross capacity (l) Net capacity (l) Width (mm) Height (mm) Depth (mm) Energy consumption T T 160 A (T TI 160 C) Fresh food comp. : 159 Fresh food comp. : 148 550 850 600 0, 41 150 A 90 34 (kWh/24h) (kWh/year) Energy class, according to EU standards Roted power (W) Weight (kg) Installing the appliance Transportation, unpacking It is recommended to deliver the appliance in original packaging, in vertical position considering the protective warning on packaging. After each transportation the appliance must not be switched on for approx. Unpack the appliance and check if there are damages on it. Report possible damages immediately to the place you bought it. In that case retain packaging. Cleaning Remove every adhesive tape, which ensure the parts not to move in the appliance. Wash the inside of the appliance using lukewarm water and mild detergent. After cleaning wipe out the inside of the appliance. 51 GB Placement The ambient temperature has an effect on the energy consumption and proper operation of the appliance. When placing, take into consideration that it is practical to operate the appliance between ambient temperature limits according to the climate class that is given in the chart below and can be found in the data label. Class of climate SN N ST Ambient temperature +10 . . . + 38 °C If the ambient temperature goes below the lower data the temperature of the cooling compartment can go beyond the prescribed temperature. If the ambient temperature goes beyond the upper data this means longer operating time of the compressor, breakdown in the automatic defrosting increasing temperature in the cooling compartment or increasing energy consumption. When placing the appliance ensure that it stands level. [. . . ] So as to avoid more severe damage, the defect must be brought to our attention immediately. Applying the guarantee is subject to the consumer providing proof of purchase showing the purchase and/or delivery date. The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. [. . . ]