User manual ZANKER UF220

[. . . ] You must read them carefully before installing or using the appliance. General safety In the event of a fault, do not attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause damage. If repairs are needed, contact an authorised service centre and ask for genuine spare parts. This appliance is designed to be used by adults. [. . . ] To drain water, press this button again (the laundry will be spun accordingly to the type of fabrics) or select the drain programme. 2 Control light It is on when the machine is started and goes off at the end of the programme. 8 Temperature selector dial 3 ON/OFF button By pressing this button the machine is switched on and off. By turning this dial to the right or to the left it is possible to select the desired temperature. Position COLD: the machine uses water taken directly from the water supply, without heating it. Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone (*), lay the garment on a soft cloth and dab the stain. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Remove any residual marks from white fabrics with bleach. Any fabric softener or starching additives must be poured into the compartment marked before starting the wash programme. Follow the product manufacturers recommendations on quantities to use and do not exceed the MAX mark in the detergent dispenser drawer. Degrees of water hardness Degrees Level Characteristic German dH 1 2 3 4 soft medium hard very hard 0- 7 8-14 15-21 French T. H. 0-15 16-25 26-37 more than 21 more than 37 13 ENGLISH 124973430 Luxus 600 gb-gr 29-01-1999 11:24 Pagina 14 (Nero pellicola colore) 3. Measure out the additive Operating sequence Before washing your first load of laundry, we recommend that you run a cotton cycle at 60C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half a measure of detergent into the main wash compartment and start up the machine. If required, pour fabric softener into the compartment marked without exceeding the MAX mark. 1. Place the laundry in the drum Open the door. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Select the required option(s) Depress one or more buttons depending on the selected programme. NO SPIN EXTRA RINSE HALF LOAD RINSE HOLD PLUS P0004 2. Measure out the detergent Pull out the dispenser drawer until it stops. Measure out the amount of detergent recommended by the manufacturer in a graduated cup and pour it into the main wash compartment . If you wish to carry out the prewash, pour detergent into the appropriate compartment marked . 5. [. . . ] Check that the door is closed. The machine fills then empties immediately: The machine does not empty and/or does not spin: There is water on the floor: The end of the drain hose is too low. Refer to relevant paragraph in water drainage section. Check that the drain hose is not squashed or kinked. A programme with the Anticrease option has been selected . [. . . ]