User manual ZANKER V314

[. . . ] Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. ried out by inexperienced persons will cause injury or serious malfunctioning. Contact your local Service Force Centre. Always insist on genuine spare parts. General safety · Dishwasher detergents can cause chemical burns to eyes, mouth and throat. [. . . ] The flashing is repeated every 5 seconds. To change the level, press the start/cancel button. Each time the button is pressed the level increases. The end of programme indicator light indicates the new setting. To memorize the operation, turn the programme selector dial to position off. Filling with dishwasher salt CAUTION!Use only special salt suitable for dishwashers. 9 Unscrew the cap. Only before filling with Using the funnel provided, salt for the first time, fill pour in the salt until the the salt container with wa- container is filled with salt. Water will overflow from the container as salt is added. Remove any trace of salt. Replace the cap tightly turning it clockwise until it stops with a click. IMPORTANT!Top up the special salt when the light on the control panel illuminates. 10 Filling with rinse aid Open the lid. Fill up with rinse aid. The Clean up any rinse aid maximum level for filling is which overflows. Close the lid and press until it indicated by "max" locks. CAUTION!Never fill the rinse aid dispenser with any other substances (e. g. For this reason, some detergent tablets do not attain their full cleaning power during short washing programmes. Therefore, please use long washing programmes when using detergent tablets, to ensure the complete removal of detergent residuals. Unloading the dishwasher · Hot dishes are sensitive to knocks. 15 The dishes should therefore be allowed to cool down before removing from the appliance. · Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. · Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. CAUTION!When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Care and cleaning Cleaning the filters IMPORTANT!NEVER use the dishwasher without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Clean filters A, B and C Turn the handle about 1/4 Remove filter A from the thoroughly under running turn anticlockwise and re- base of the washing commove filters B and C. partment. 16 Put the flat filter A back in Replace the filters and the base of the washing lock by turning the handle compartment and ensure clockwise to the stop. that it fits perfectly under the two guidesD. Cleaning the spray arms NEVER try to remove the spray arms. If residues of soil have clogged the holes in the spray arms, remove them with a cocktail stick. Prolonged periods of nonoperation If you are not using the machine for any prolonged period of time you are advised to: 1. Unplug the appliance and then turn off the water. [. . . ] If the water inlet hose or the safety valve is damaged, remove the mains plug immediately. A water inlet hose with safety valve MUST only be replaced by your local Service Force Centre. WARNING!The electrical cable for the safety valve is in the double-walled water inlet hose and is live. Therefore do not immerse the water inlet hose or the safety valve in water. Drain hose Connect drain hose to the The waste connection sink. [. . . ]