User manual ZANKER ZKG8408

[. . . ] The appliance must not be located close to radiators or gas cookers. Avoid prolonged exposure of the appliance to direct sunlight. There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided. For freezers only (except built-in models): an ideal location is the cellar or basement. [. . . ] This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. For building into kitchen units follow the special "Building-in" instructions given. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 41 50 mm Dimensions of the recess Height Depth Width 880 mm 550 mm 560 mm min. cm 200 2 The appliance's door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. Push appliance into the housing until stop strip (A) touches the kitchen unit. D567 min. 200 cm Instructions for totally built-in appliances Fig. 2 A D022 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Fig. 3 PR162 42 Press in the joint covers between the appliance and the kitchen unit. Fig. 4 D724 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 5 B D726 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 6 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 6 H 20m m D094 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. [. . . ] During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: pull out the plug from the wall socket or turn the thermostat knob to the «O» setting; remove any stored food, wrap it in several layers of newspaper and put it in a cool place; leave the door open, and insert the plastic scraper in the appropriate seating at the bottom centre, placing a basin underneath to collect the defrost water; when defrosting is completed, dry the interior thoroughly; keep the scraper for future use; turn the thermostat knob back to the required setting D068 Fig. [. . . ]