User manual ZANKER ZKH7513W

[. . . ] Installation and initial adjustment of your oven MUST be carried out by qualified personnel in compliance with current regulations. Specific installation instructions for the installer are given in this booklet. Before any maintenance or cleaning work is carried out on the appliance, always turn off the isolator switch at the cooker point, and allow to cool. Ensure that the shelves are put in place in the correct way. [. . . ] The oven door should not be opened before at least 3/4 of the set cooking time is up. Normal short pastry dough should be cooked in a mould or tin for 2/3 of total cooking time required and then garnished as desired before being cooked completely. Clearly, the remaining cooking time depends on the type of garnish used (jam, fruit, etc. ). Care should be taken to ensure that any dough and cake mixes are of the right consistency since an unduly moist mix lengthens cooking time unnecessarily. The raw dough or mix should therefore be fairly difficult to detach from the spoon or beater. If three shelves are filled with cakes and tarts simultaneously, it is advisable to slot in an extra shelf between the two lower shelves (Fig. For cooking meat and fish Meat cooked in the oven should weigh at least 1 kg to prevent it from becoming too dry during cooking. Very tender red meat to be cooked rare, i. e. well cooked on the outside but extremely juicy inside, requires high-temperature cooking (200-220°C). White meat, poultry and fish instead require low-temperature cooking (150-175°C). The ingredients for the accompanying sauce or gravy should be put in the baking pan at the very beginning only when cooking times are short. Wash the filter after use using warm soapy water. 6 grease filter only when roasting. 60 Cleaning and Maintenance Before any cleaning switch the oven off and let it cool down. Never use steam or steam machines to clean the appliance. Before carrying out maintenance and cleaning operations, make sure that your oven is disconnected from the mains power supply. Cleaning must be carried out after the oven has cooled down. Wash the enamelled parts with lukewarm water and detergent. Do not use abrasive products, such as steel wool pads, acids etc. since these could damage the various surfaces. Rinse stainless steel parts with water after use, and dry them with a soft cloth or chamois leather. In the case of persistent stains, you can use normal non-abrasive detergents or products specific for stainless steel readily available on the market. Another alternative is a drop of hot vinegar. [. . . ] Performing the guarantee means that the appliance is returned to the condition it was in before the defect occurred. Defective parts are replaced or repaired. Parts replaced free of charge become our property. So as to avoid more severe damage, the defect must be brought to our attention immediately. [. . . ]