User manual ZANKER ZKK9408

[. . . ] Ice lollies can cause frost burns if consumed straight from the appliance. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. The appliance must not be located close to radiators or gas cookers. Avoid prolonged exposure of the appliance to direct sunlight. [. . . ] This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 47 Instructions for totally built-in appliances Dimensions of the recess Model Height Depth Width ZKK 9408 880 mm 550 mm 560 mm ZKK 9410 1030 mm 550 mm 560 mm ZKK 9412 1225 mm 550 mm 560 mm 50 mm The appliance's door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. Push appliance into the housing until stop strip (A) touches the kitchen unit. min. 2 A D022 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Fig. 3 PR162 48 Press in the joint covers between the appliance and the kitchen unit. Fig. 4 D724 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 5 B D726 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 6 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 6 H 20m m D094 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 7 8mm PR34 49 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 8 PR35 Inner door reversal Using a screwdriver release bracket (1) by pressing on the internal spring (Fig. [. . . ] After two or three hours, reload the previously removed food into the compartment. 13 PR151 Important A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. 55 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. GB Interior light The light bulb inside the refrigerator compartment can be reached as follows: s s unscrew the light cover securing screws; unhook the moving part by pressing it as shown in the figure. Periodic cleaning Never use metal objects for cleaning your appliance as it may get damaged. Clean the inside with warm water and bicarbonate of soda. [. . . ]