User manual ZANKER ZKK9417K

[. . . ] Kühl-Gefrierschrank Réfrigérateur-congélateur Koel-vrieskast Fridge-freezer ZANKER ZKK 9417 K Gebrauchsanweisung Mode d'emploi Gebruiksaanwijzing Instruction booklet 2222 196-71 CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 40 41 41 41 41 42 43 45 45 45 45 45 45 45 46 46 46 46 47 47 47 47 47 48 48 49 49 49 49 49 Installation . Positioning . Electrical connection . . Control panel Use of the freezer . [. . . ] 1) P P A D B C D C P1 D337 P1 Fig. 1 Right opening Remove the pins (P) and (P1). Left opening Remove (P) from both sides and the door. Remove (A) from the left side and (B-C-D) from the right side. Refit (B-C-D) on the left side and (A) on the right side. Refit the door and (P) on the left side. Remove (P1) from the right side. 42 Building-in instructions Housing dimensions Height Depth Width 1780 mm 550 mm 560 mm Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Fig. 4 For safety reasons, minimum ventilation must be as shown in Fig. 2: Attention: keep ventilation openings clear of obstruction. 50 mm min. cm 200 2 Press in the joint covers between the appliance and the kitchen furniture. Fig. 5 D526 Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. 3 A D724 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 6 D023 B D726 43 Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. 7 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 7 In case of side fixing of the appliance, it will be sufficient to loose the screws fixing the bracket (E) and to position it as shown in Fig. 10 50mm A 20m PR166 E m D735 E Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 8 8mm PR167 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. [. . . ] Fruit and vegetables: these should be thoroughly cleaned and placed in the special drawer(s) provided. D026 47 Fig. 14 pull out the plug from the wall socket or turn the thermostat knob to the «O» setting; remove any stored food, wrap it in several layers of newspaper and put it in a cool place; leave the door open, and insert the plastic scraper in the appropriate seating at the bottom centre, placing a basin underneath to collect the defrost water; Fig. 16 D006 Defrosting Refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. [. . . ]