User manual ZANKER ZKL360A

[. . . ] This appliance is designed for storing food, domestic use according to these instructions only. Specialised companies that are qualified to do so by the manufacturer must carry out service and repairs including repairing and changing the power cord. Accessory parts supplied by them should be used only for repairing. Otherwise the appliance can be damaged or can cause other damage or injury. [. . . ] The tray in figure is not a piece of accessories to the appliance!When ice coating is so thick that it cannot be removed with the plastic scraper, the cooling plate has to be defrosted. Frequency of defrosting depends on usage (generally 2-3 times a year). Take the frozen foods out of the appliance, and put them into a basket lined with paper or cloth. Store them in a possibly cool place or replace them into another refrigerator. 61 GB Pull out the mains plug from the mains socket, so both parts of the appliance are out of operation. Open the doors of both parts of the appliance and clean the refrigerator according to 'Regular cleaning'. Maintain and clean the freezer as following: Sweep the melting water with a cloth or sponge off the cooling plate. The melting water swept down gathers in the bottom of the appliance and can be removed with a hygroscopic cloth or a sponge. Put the mains plug into the mains socket and put foods taken out back to their places. It is recommended to operate the appliance at the highest position of the thermostatic control for some hours so that it can reach the sufficient storing temperature as soon as possible. Regular cleaning It is recommended to wash the inside of the refrigerator in 3-4 weeks time using lukewarm water then wipe it (it is practical to clean the inside of the freezer and defrost it at a time). Water flows onto the The melting water outlet flows not into the evaporative tray above the floor. There are too much frost Products are not wrapped properly. Doors are not shut properly or do not close tightly. The thermostatic control can be set wrongly. The compressor The thermostatic control is set wrongly. Doors are not shut properly or do not close tightly. Products in big quantity to be frozen were put in. Solution Set the thermostat knob to higher position. Place the products to the appropriate place. Check if the door closes well and the gasket is unhurt and clean. Set the thermostat knob to higher position. [. . . ] Performing the guarantee means that the appliance is returned to the condition it was in before the defect occurred. Defective parts are replaced or repaired. Parts replaced free of charge become our property. So as to avoid more severe damage, the defect must be brought to our attention immediately. [. . . ]